S-L2985B30-H4T1 Seiko Instruments, S-L2985B30-H4T1 Datasheet - Page 13

• Manufacturer Part Number: S-L2985B30-H4T1
• Description: IC REG LDO 150MA 3.0V WLP-4B
• Manufacturer: Seiko Instruments

Specifications of S-L2985B30-H4T1

• Regulator Topology: Positive Fixed
• Voltage - Output: 3V
• Voltage - Input: Up to 6.5V
• Voltage - Dropout (typical): 0.19V @ 100mA
• Number Of Regulators: 1
• Current - Output: 150mA (Min)
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: WLP-4B
• Number Of Outputs: 1
• Polarity: Positive
• Input Voltage Max: 6.5 V
• Output Voltage: 3 V
• Output Type: Fixed
• Dropout Voltage (max): 0.26 V at 100 mA
• Output Current: 150 mA
• Line Regulation: 0.2 % / V
• Load Regulation: 40 mV
• Voltage Regulation Accuracy: 1 %
• Maximum Power Dissipation: 0.35 W
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Minimum Operating Temperature: - 40 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Current - Limit (min): -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Rev.3.0
Precautions
Precautions for WLP package
• Wiring patterns for the VIN, VOUT and GND pins should be designed so that the impedance is low.
• Note that the output voltage may increase when a series regulator is used at low load current (1.0 mA or
• Generally a series regulator may cause oscillation, depending on the selection of external parts. The
• The voltage regulator may oscillate when the impedance of the power supply is high and the input
• The application conditions for the input voltage, output voltage, and load current should not exceed the
• The side of device silicon substrate is exposed to the marking side of device package. Since this portion
• In this package, the overcoat of the resin of translucence is carried out on the side of device. Keep it
• Do not apply an electrostatic discharge to this IC that exceeds the performance ratings of the built-in
• In determining the output current, attention should be paid to the output current value specified in Table
• SII claims no responsibility for any disputes arising out of or in connection with any infringement by
• The side of device silicon substrate is exposed to the marking side of device package. Since this portion
• In this package, the overcoat of the resin of translucence is carried out on the side of device area. Keep
HIGH RIPPLE-REJECTION WLP PACKAGE LOW DROPOUT CMOS VOLTAGE REGULATOR
When mounting an output capacitor(C
VOUT pin and to the VSS pin should be as short as possible.
less).
following conditions are recommended for this IC. However, be sure to perform sufficient evaluation
including the temperature characteristic in the actual usage conditions to select the series regulator.
capacitor is small or an input capacitor is not connected.
package power dissipation.
has lower strength against the mechanical stress than the standard plastic package, be careful of the
handing of a package enough against chip, crack etc. Moreover, the exposed side of silicon has
electrical potential of device substrate, and needs to be kept out of contact with the external potential.
mind that it may affect the characteristic of a device when exposed a device in the bottom of a high light
source.
electrostatic protection circuit.
4 in the electrical characteristics and footnote *5) of the table.
products including this IC of patents owned by a third party.
has lower strength against the mechanical stress than the standard plastic package, chip, crack, etc
should be careful of the handing of a package enough. Moreover, the exposed side of silicon has
electrical potential of device substrate, and needs to be kept out of contact with the external potential.
it mind that it may affect the characteristic of a device when exposed a device in the bottom of a high
light source.
_00
Input capacitor (C
Output capacitor (C
Equivalent series resistance (ESR): 10 Ω or less
IN
):
L
):
L
) or an input capacitor(C
1.0 μF or more
0.47 μF or more
Seiko Instruments Inc.
IN
), the distance from the capacitor to the
S-L2985 Series
13