LT3008ITS8-5#TRMPBF Linear Technology, LT3008ITS8-5#TRMPBF Datasheet - Page 16

• Manufacturer Part Number: LT3008ITS8-5#TRMPBF
• Description: IC REG LDO 5.0V 20MA TSOT23-8
• Manufacturer: Linear Technology

Specifications of LT3008ITS8-5#TRMPBF

• Regulator Topology: Positive Fixed
• Voltage - Output: 5V
• Voltage - Input: Up to 45V
• Voltage - Dropout (typical): 0.3V @ 20mA
• Number Of Regulators: 1
• Current - Output: 20mA
• Current - Limit (min): 22mA
• Operating Temperature: -40°C ~ 125°C
• Mounting Type: Surface Mount
• Package / Case: TSOT-23-8, TSOT-8
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

LT3008 Series
APPLICATIONS INFORMATION
The SHDN pin cannot be driven below GND unless tied to
the IN pin. If the SHDN pin is driven below GND while IN
is powered, the output will turn on. SHDN pin logic cannot
be referenced to a negative rail.
The LT3008 incurs no damage if OUT is pulled below
ground. If IN is left open circuit or grounded, OUT can be
pulled below ground by 50V. No current fl ows from the
pass transistor connected to OUT. However, current fl ows
in (but is limited by) the resistor divider that sets output
voltage. Current fl ows from the bottom resistor in the
divider and from the ADJ pin’s internal clamp through the
top resistor in the divider to the external circuitry pulling
OUT below ground. If IN is powered by a voltage source,
OUT sources current equal to its current limit capability and
the LT3008 protects itself by thermal limiting if necessary.
In this case, grounding the SHDN pin turns off the LT3008
and stops OUT from sourcing current.
The LT3008 incurs no damage if the ADJ pin is pulled
above or below ground by 50V. If IN is left open circuit or
grounded, ADJ acts like a 100k resistor in series with a
diode when pulled above or below ground.
In circuits where a backup battery is required, several
different input/output conditions can occur. The output
voltage may be held up while the input is either pulled
16
to ground, pulled to some intermediate voltage or is left
open circuit. Current fl ow back into the output follows the
curve shown in Figure 6.
If the LT3008 IN pin is forced below the OUT pin or the
OUT pin is pulled above the IN pin, input current typically
drops to less than 1μA. This occurs if the LT3008 input is
connected to a discharged (low voltage) battery and either
a backup battery or a second regulator circuit holds up
the output. The state of the SHDN pin has no effect in the
reverse current if OUT is pulled above IN.
100
90
80
70
60
50
40
30
20
10
0
Figure 6. Reverse-Output Current
0
1
OUTPUT AND ADJ VOLTAGE (V)
2
3
4
ADJ CURRENT
5
6
OUT CURRENT
7
8
3008 F06
9
10
3008fb