DS1834 Maxim Integrated Products, DS1834 Datasheet - Page 4

• Manufacturer Part Number: DS1834
• Description: IC ECONORST DUAL ACT LO PP 8-DIP
• Manufacturer: Maxim Integrated Products
• Series: EconoResetr
• Type: Multi-Voltage Supervisorr

Specifications of DS1834

• Number Of Voltages Monitored: 2
• Output: Open Drain or Open Collector
• Reset: Active Low
• Reset Timeout: 200 ms Minimum
• Voltage - Threshold: 3.3V, 5V
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Through Hole
• Package / Case: 8-DIP (0.300", 7.62mm)
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

DS1834/A/D
OUTPUT VALID CONDITIONS
All versions of the DS1834 can maintain valid outputs as long as one input remains above 1.2 volts.
However, the
outputs on the DS1834 use a push-pull output structure which can maintain a valid
RST
output below 1.2 volts. To sink current below 1.2 volts a resistor can be connected from
to GND
RST
(see Figure 5). This arrangement will maintain a valid value on the
outputs even if all inputs are at 0
RST
volts. During both power-up and power-down this arrangement will draw current when
is in the high
RST
state. A value of about 100 k =should be adequate to maintain a valid condition.
The DS1834A requires pull-up resistors on the outputs to maintain a valid output. The value of the
resistors is not critical in most cases but must be set low enough to pull the output to a high state. A
common value used is 10 k s (see Figure 6 and Figure 7).
APPLICATION DIAGRAM:
VALID TO 0 VOLTS V
ON THE DS1834 Figure 5
RST
CC
APPLICATION DIAGRAM: DS1834A NMOS OUTPUTS Figure 6
Note: If outputs are pulled-up to different voltages the outputs can not be connected to form a wired
"AND".
APPLICATION DIAGRAM: DS1834A WIRED "AND" OUTPUT Figure 7
4 of 7