FG-23742-D36 Knowles Acoustics, FG-23742-D36 Datasheet - Page 27

• Manufacturer Part Number: FG-23742-D36
• Description: MIC ELECTRET OMNI W/LEADS
• Manufacturer: Knowles Acoustics
• Series: FG/BFGr
• Type: Electret Condenserr

Specifications of FG-23742-D36

• Sensitivity: -63dB ±3dB
• Voltage - Rated: 1.3V
• Current: 50µA
• Size / Dimension: Circular - 2.55mm Dia x 2.57mm H
• Impedance: 4.4K Ohm
• Frequency: 100Hz ~ 10kHz
• Termination: Wire Leads
• Direction: Omnidirectional
• Port Location: Top
• Directional Properties: Omnidirectional
• Operating Voltage: 0.9 V to 1.6 V
• Termination Style: Wire Leads
• Dimensions: 2.565 mm L
• Diameter: 2.565 mm
• Length: 2.565 mm
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Filter Type: -
• S/n Ratio: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 423-1068; FG-3742-D36

MICROPHONE AND SPEAKER BASICS
SPEAKERS
The speaker converts an electrical signal into sound. A cross section of a typical Knowles speaker is shown in Fig. 3.
The basic components of the speaker are: a coil of wire, a metal U-shaped reed called the armature, a pair of permanent
magnets, a drive rod, and a diaphragm.
The coil and armature act as an electromagnet. An alternating current in the coil causes the polarity of the armature to
switch back and forth from north to south. The free end of the armature bends slightly up and down as it is attracted
alternately to the top and bottom magnets (Fig. 4). The diaphragm, pulled along by the drive rod, pumps air in and out of
the speaker. The mechanical motion of the armature is thus converted into sound.
The sound output of a typical Knowles’ speaker is measured in units of dB SPL (sound pressure level) relative to 20 µPa.
Fig. 3: Cross section of a Knowles EH speaker
DIAPHRAGM
DRIVE ROD
OUTPUT TERMINAL
COIL
MAGNETS
ARMATURE
Fig. 4: The motor of the speaker has a coil, an armature, and a pair of permanent magnets.
www.knowles.com
27
Note: All performance curves are typical