ADA4062-4ARUZ Analog Devices Inc, ADA4062-4ARUZ Datasheet - Page 5

• Manufacturer Part Number: ADA4062-4ARUZ
• Description: IC OPAMP JFET 1.4MHZ QD 14TSSOP
• Manufacturer: Analog Devices Inc

Specifications of ADA4062-4ARUZ

• Slew Rate: 3.3 V/µs
• Amplifier Type: J-FET
• Number Of Circuits: 4
• Gain Bandwidth Product: 1.4MHz
• Current - Input Bias: 2pA
• Voltage - Input Offset: 750µV
• Current - Supply: 165µA
• Current - Output / Channel: 20mA
• Voltage - Supply, Single/dual (±): 8 V ~ 36 V, ±4 V ~ 18 V
• Operating Temperature: -40°C ~ 125°C
• Mounting Type: Surface Mount
• Package / Case: 14-TSSOP
• Op Amp Type: Low Power
• No. Of Amplifiers: 4
• Bandwidth: 1.4MHz
• Supply Voltage Range: ± 5V To ± 15V
• Amplifier Case Style: TSSOP
• No. Of Pins: 14
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Output Type: -
• -3db Bandwidth: -
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

ABSOLUTE MAXIMUM RATINGS
Table 3.
Parameter
Supply Voltage
Input Voltage
Differential Input Voltage
Input Current
Output Short-Circuit Duration to GND
Storage Temperature Range
Operating Temperature Range
Junction Temperature Range
Lead Temperature (Soldering, 60 sec)
Stresses above those listed under Absolute Maximum Ratings
may cause permanent damage to the device. This is a stress
rating only; functional operation of the device at these or any
other conditions above those indicated in the operational
section of this specification is not implied. Exposure to absolute
maximum rating conditions for extended periods may affect
device reliability.
Rating
±18 V
±V
±V
±10 mA
Indefinite
−65°C to +150°C
−40°C to +125°C
−65°C to +150°C
300°C
SY
SY
Rev. B | Page 5 of 20
THERMAL RESISTANCE
θ
soldered in a circuit board for surface-mount packages. It was
measured using a standard 4-layer board.
Table 4. Thermal Resistance
Package Type
8-Lead SOIC
8-Lead MSOP
10-Lead LFCSP
14-Lead TSSOP
16-Lead LFCSP
POWER SEQUENCING
The supply voltages of the op amps must be established
simultaneously with, or before, any input signals are applied. If
this is not possible, the input current must be limited to 10 mA.
ESD CAUTION
JA
is specified for the worst-case conditions, that is, a device
ADA4062-2/ADA4062-4
θ
120
142
132
112
75
JA
θ
45
45
46
35
12
JC
Unit
°C/W
°C/W
°C/W
°C/W
°C/W