DSPIC30F4013T-20I/PT Microchip Technology, DSPIC30F4013T-20I/PT Datasheet - Page 15

• Manufacturer Part Number: DSPIC30F4013T-20I/PT
• Description: IC DSPIC MCU/DSP 48K 44TQFP
• Manufacturer: Microchip Technology
• Series: dsPIC™ 30Fr

Specifications of DSPIC30F4013T-20I/PT

• Core Processor: dsPIC
• Core Size: 16-Bit
• Speed: 20 MIPS
• Connectivity: CAN, I²C, SPI, UART/USART
• Peripherals: AC'97, Brown-out Detect/Reset, I²S, POR, PWM, WDT
• Number Of I /o: 30
• Program Memory Size: 48KB (16K x 24)
• Program Memory Type: FLASH
• Eeprom Size: 1K x 8
• Ram Size: 2K x 8
• Voltage - Supply (vcc/vdd): 2.5 V ~ 5.5 V
• Data Converters: A/D 13x12b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 44-TQFP, 44-VQFP
• For Use With: AC30F006 - MODULE SKT FOR DSPIC30F 44TQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: DSPIC30F4013T20IP

26. Page 15-6, Register 15-2: PTMR: PWM
Register 15-2:
27. Page 15-32, Section 15.10 PWM Fault
 2004 Microchip Technology Inc.
Upper Byte:
bit 15
bit 14-0
PTDIR
R-0
On page 15-32, Section 15.10 PWM Fault Pins,
paragraph 2 should be replaced with the following:
Time Base Register, bit 14-0
On page 15-6, Register 15-2: PTMR: PWM Time
Base Register, the description of bit 0 through
bit 14 should be replaced as follows. All other bit
definitions do not change and hence are not
described.
Pins
PTMR <14:0>: PWM Timebase Register Count Value
Legend:
R = Readable bit
-n = Value at POR
R/W-0
PTMR: PWM Time Base Register
Lower Byte:
bit 7
R/W-0
The fault pins may have other multiplexed functions depending on the dsPIC device variant.
When used as a fault input, each fault pin is readable via its corresponding PORT register. The
FLTA and FLTB pins function as active low inputs so that it is easy to wire-OR many sources to
the same input through an external pull-up resistor. When not used with the PWM module, these
pins may be used as general purpose I/O or another multiplexed function. Each fault pin has
its own interrupt vector, interrupt flag bit, interrupt enable bit, and interrupt priority bits associated
with it.
R/W-0
R/W-0
W = Writable bit
‘1’ = Bit is set
dsPIC30F Family Reference Manual
R/W-0
R/W-0
PTMR <14:8>
R/W-0
R/W-0
PTMR <7:0>
R/W-0
U = Unimplemented, read as ‘0’
‘0’ = Bit is cleared
R/W-0
R/W-0
R/W-0
R/W-0
x = Bit is unknown
bit 8
R/W-0
DS80169E-page 15
R/W-0
bit 0