PIC18F2431-E/SP Microchip Technology, PIC18F2431-E/SP Datasheet - Page 4

• Manufacturer Part Number: PIC18F2431-E/SP
• Description: IC MCU FLASH 8KX16 28-DIP
• Manufacturer: Microchip Technology
• Series: PIC® 18Fr

Specifications of PIC18F2431-E/SP

• Core Size: 8-Bit
• Program Memory Size: 16KB (8K x 16)
• Core Processor: PIC
• Speed: 40MHz
• Connectivity: I²C, SPI, UART/USART
• Peripherals: Brown-out Detect/Reset, LVD, Power Control PWM, QEI, POR, PWM, WDT
• Number Of I /o: 24
• Program Memory Type: FLASH
• Eeprom Size: 256 x 8
• Ram Size: 768 x 8
• Voltage - Supply (vcc/vdd): 4.2 V ~ 5.5 V
• Data Converters: A/D 5x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 125°C
• Package / Case: 28-DIP (0.300", 7.62mm)
• Controller Family/series: PIC18
• No. Of I/o's: 24
• Eeprom Memory Size: 256Byte
• Ram Memory Size: 768Byte
• Cpu Speed: 40MHz
• No. Of Timers: 4
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: I3-DB18F4431 - BOARD DAUGHTER ICEPIC3AC164035 - MODULE SKT FOR 18F2X31 28SOICDVA18XP280 - DEVICE ADAPTER 18F2220 PDIP 28LD
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

PIC18F2331/2431/4331/4431
17. Module: EUSART
18. Module: EUSART
DS80180C-page 4
Writing to the USART/EUSART TXREG register
faster than the baud rate in Synchronous mode
will overwrite the previous value instead of
double-buffering as in Asynchronous mode.
Work around
Load the first character into TXREG and then wait
for a TX interrupt, or check the TXIF bit before
writing each additional character to TXREG.
The EUSART cannot receive asynchronous data at
the four fastest baud rates (BRGH = 1, BRG16 = 1
and SPBRG < 4).
Work around
Use a slower baud rate or a faster system clock
speed.
19. Module: HSADC
A ΔI
(for V
put into Sleep mode with the HSADC enabled
(ADON = 1) without setting the GO/DONE bit so
that at least one conversion is performed.
Observed ΔI
Work around
If no conversion will be done while in Sleep mode,
disable the HSADC module by clearing the ADON
bit before entering Sleep mode.
If power consumption is an issue for the applica-
tion, do not put the part into Sleep mode with the
HSADC enabled if no conversion is to be
performed.
AD
DD
(parameter D026) of greater than 300 μA
= 3V) is observed when the device is
AD
will increase in proportion to V
© 2005 Microchip Technology Inc.
DD
.