SAK-XC888CM-8FFA AB Infineon Technologies, SAK-XC888CM-8FFA AB Datasheet - Page 36

• Manufacturer Part Number: SAK-XC888CM-8FFA AB
• Description: IC MCU 8BIT 256B TQFP-64
• Manufacturer: Infineon Technologies
• Series: XC8xxr

Specifications of SAK-XC888CM-8FFA AB

• Core Processor: XC800
• Core Size: 8-Bit
• Speed: 103.2MHz
• Connectivity: CAN, SSI, UART/USART
• Peripherals: Brown-out Detect/Reset, POR, PWM, WDT
• Number Of I /o: 48
• Program Memory Size: 32KB (32K x 8)
• Program Memory Type: FLASH
• Ram Size: 1.75K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 8x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 125°C
• Package / Case: 64-LFQFP
• For Use With: B158-H8743-X-X-7600IN - KIT STARTER XC886/888MCBXC88X - BOARD EVAL FOR INFINEON XC88X
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Other names: SAK-XC888CM-8FFA AB; SAK-XC888CM-8FFAABINTR; SAKXC888CM8FFAT

Field
OP
0
3.2.3
The bit protection scheme prevents direct software writing of selected bits (i.e., protected
bits) using the PASSWD register. When the bit field MODE is 11
bit field PASS opens access to writing of all protected bits, and writing 10101
field PASS closes access to writing of all protected bits. In both cases, the value of the
bit field MODE is not changed even if PASSWD register is written with 98
only be changed when bit field PASS is written with 11000
PASSWD register disables the bit protection scheme.
Note that access is opened for maximum 32 CCLKs if the “close access” password is not
written. If “open access” password is written again before the end of 32 CCLK cycles,
there will be a recount of 32 CCLK cycles. The protected bits include the N- and K-
Divider bits, NDIV and KDIV; the Watchdog Timer enable bit, WDTEN; and the power-
down and slow-down enable bits, PD and SD.
Data Sheet
Bit Protection Scheme
Bits
[7:6]
3
Type Description
w
r
Operation
0X
10
11
Reserved
Returns 0 if read; should be written with 0.
Manual page mode. The value of STNR is
ignored and PAGE is directly written.
New page programming with automatic page
saving. The value written to the bit positions of
PAGE is stored. In parallel, the previous
contents of PAGE are saved in the storage bit
field STx indicated by STNR.
Automatic restore page action. The value
written to the bit positions PAGE is ignored
and instead, PAGE is overwritten by the
contents of the storage bit field STx indicated
by STNR.
29
B
, for example, writing D0
Functional Description
B
, writing 10011
XC886/888CLM
H
or A8
V1.2, 2009-07
B
to the bit
H
B
. It can
to the
H
to