CABLE-SMBUS-3PIN Analog Devices Inc, CABLE-SMBUS-3PIN Datasheet - Page 18

• Manufacturer Part Number: CABLE-SMBUS-3PIN
• Description: CABLE SMBUS 3PIN
• Manufacturer: Analog Devices Inc

Specifications of CABLE-SMBUS-3PIN

• Rohs Status: RoHS non-compliant
• Accessory Type: SMBus Cable
• For Use With/related Products: EVALADM106x Boards

EVAL-ADM106x
Figure 22. ADM106x s/w launch- ADM1062 offline
offline mode. Clicking NO> will close the software. The user can
then power up an Evaluation board with an ADM106x inserted in its
socket and restart the software.
Once YES> is clicked, the window shown in Figure 23 appears:-
Figure 23. ADM106x s/w launch- ADM1062 offline
When starting up the software in Offline mode, the system needs to
be told which device the user wishes to program, this can be
selected by clicking the relevant box.
Figure24. Selecting an ADM1062 to program offline
Click OK> to continue the software launch.
By choosing select all (as shown in figure 19) the device to be
programmed can be changed at any time by left clicking a
dropdown window located in the top right corner of the Top Level
screen.
Click YES> in the dialog box above to operate the software in
Rev. PrB | Page 18 of 38
VIRTUAL DEVICE
The ADM106x Configuration Tool is designed to be as
functional when working without a connected Evaluation board
as it is when working with a board. This is referred to as
working offline or online. When working offline the only
difference is that the device cannot be stimulated by the
evaluation board features. However all features of the device
from the sequencing engine (see later section) to the input and
output configuration settings can be programmed. In essence
working offline is working with a virtual device. All these
settings can be saved to file and recalled later either online or
offline. It is recommended to emulate operation with a
connected evaluation board to observe in circuit device
behavior before implementing the device to perform its
intended purpose. As mentioned on Startup in offline mode the
device must be specified by selecting from an option screen as
shown in figure 22 Any features not available on a selected
device will not be enabled in the Configuration Tool. All
settings should be saved before exiting the software.
Depending on whether the software is being run in on-line or
off-line mode, one of the two following windows will appear:-
Figure 25. ADM1062 Top Level, device online
TOP LEVEL
This indicates the Software and
Configuration versions.
This indicates the device
currently being configured.
Preliminary Technical Data
This indicates the
calculated checksums of
the device EEPROM