HS0005KCU04H Renesas Electronics America, HS0005KCU04H Datasheet - Page 50

• Manufacturer Part Number: HS0005KCU04H
• Description: EMULATOR E10A-USB SUPERH RISC
• Manufacturer: Renesas Electronics America
• Type: In Circuit Debuggerr

Specifications of HS0005KCU04H

• Contents: Emulation Module
• For Use With/related Products: SH7205, SH7265
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

(1) The connector must be installed to the user system. Table 3.2 shows the recommended
Table 3.2 Recommended H-UDI Port Connector
Connector
14-pin connector
38-pin connector
Notes: 1. When designing the 14-pin connector layout on the user board, do not place any
(2) The pin assignments of the connector are shown in section 2, in the additional document,
(3) Connect pins 5 and GND bus read located in the center of the H-UDI port connector (when
Rev. 2.00 Nov. 19, 2009 Page 28 of 294
REJ10J1766-0200
connector for the emulator.
″Supplementary Information on Using the SHxxxx″.
using the 38-pin user system interface cable) and pins 9, 10, 12, 13, and 14 (when using the 14-
pin user system interface cable) of the H-UDI port connector to GND firmly on the PCB.
These pins are used as electrical GND and to monitor the connection of the H-UDI port
connector. Note the pin assignments of the H-UDI port connector.
2. The H-UDI is an interface compatible with the Joint Test Action Group (JTAG)
components within 3 mm of the H-UDI port connector.
When designing the 36-pin connector layout on the user board, do not connect other
signal lines to the H-UDI port connector.
specifications.
Type Number
2514-6002
2-5767004-2
Manufacturer
Minnesota Mining &
Manufacturing Ltd.
Tyco Electronics AMP K.K.
Specifications
14-pin straight type
38-pin Mictor connector