HS0005KCU11H Renesas Electronics America, HS0005KCU11H Datasheet - Page 53

• Manufacturer Part Number: HS0005KCU11H
• Description: EMULATOR E10A-USB H8S(X),SH2(A)
• Manufacturer: Renesas Electronics America
• Type: In Circuit Debuggerr

Specifications of HS0005KCU11H

• Contents: E10A-LITE, Cable and CD-ROM
• Core Architecture: H8S, H8SX And SH2
• Kit Contents: E10A-LITE, Cable And CD-ROM
• Features: H-UDI Interface, 14-Way Cable
• Tool / Board Applications: General Purpose MCU, MPU, DSP, DSC
• Core Sub-architecture: H8S, H8SX, SH2
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• For Use With/related Products: H8S, H8SX, SH-2, SH-2A
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Contains lead / RoHS non-compliant

(4) Turn the setup switch (SW1) to ‘0’, connect the USB cable again, and click the [OK] button.
Notes: 1. If the following dialog message is displayed, insert the USB cable again.
cable while setting up the emulator. The emulator may be
damaged.
Setting up the emulator’s firmware is started.
2. When [Add New Hardware Wizard] is displayed, select the [Search for the best driver
3. When using Windows
Do not turn off the host computer or disconnect the USB
for your device. (Recommended)] radio button and then the [Specify a location] check
box to select the path to be searched for drivers. The location must be specified as
<Drive>:\DRIVERS. (<Drive> is the CD drive letter.)
The above case only applies when the emulator is setup initially or the USB port on the
host computer side is changed and used for first connection. The time may be required
until [Add New Hardware Wizard] is displayed.
the disconnection of the USB. However, this is not a problem.
Figure 3.20 [Setup tool for H8S E10A-USB Emulator] Dialog Box (3)
Figure 3.21 Start of Setting up the Emulator
®
2000 or Windows
CAUTION
®
XP, a dialog box will be displayed to show
Rev. 12.00 Aug. 28, 2009 Page 33 of 188
Section 3 Preparation before Use
REJ10J1140-1200