DEMO9S08QE32 Freescale Semiconductor, DEMO9S08QE32 Datasheet - Page 10

• Manufacturer Part Number: DEMO9S08QE32
• Description: DEMO FOR S08 AND QE32/16
• Manufacturer: Freescale Semiconductor
• Series: Flexis™r
• Type: MCUr

Specifications of DEMO9S08QE32

• Contents: Board, Cable, CD
• Processor To Be Evaluated: MC9S08QE32
• Data Bus Width: 8 bit
• Interface Type: RS-232, USB
• Silicon Manufacturer: Freescale
• Core Architecture: HCS08
• Core Sub-architecture: HCS08
• Silicon Core Number: MC9S08
• Silicon Family Name: Flexis - S08QE
• Kit Contents: Board
• Rohs Compliant: Yes
• For Use With/related Products: MC9S08QE32
• For Use With: DEMOACEX - BOARD EXPANSION FOR DEMO KIT
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

3.3.2
3.4
6
Quick Startup
Installing P&E Resources
Use the DEMOQE Resources CD-ROM to access and install P&E resources
for the DEMO9S08QE32. These materials are not required for operation. The
support materials contained on the DEMOQE Resources CD-ROM are listed
in Section 1.4 - Recommended Materials On DEMOQE Resources CD.
Only a few steps are required to get the DEMO9S08QE32 up and running:
Step 1.
Step 2.
Step 3.
Step 4.
Step 5.
Step 6.
If you do not have CodeWarrior Development Studio version 6.0
installed on your computer, please install it using the
accompanying CD-ROM. Additional information regarding
CodeWarrior can be found at www.freescale.com.
Remove the DEMO9S08QE32 demonstration board from its anti-
static pouch. The green DC9S08QE32 daughter card should be
plugged into the header on the base board.
Connect the USB cable from your computer to the
DEMO9S08QE32 demonstration board. Depending on your
operating system, you may need to follow steps to install the USB
driver from the DEMOQE Resources CD-ROM. Once the USB
cable is connected properly the green USB LED on the
DEMO9S08QE32 should illuminate.
Turn on the DEMO9S08QE32 power switch (K6). The red Power
LED should illuminate.
Press the buttons labelled PTA2 and PTA3. When each button is
pressed a different tone will be emitted, and the light intensity of
the PTC0 LED will change. The LEDs labelled PTC1 and PTC2
(for PTA2) or PTC3 and PTC4 (for PTA3) should illuminate. In
addition, the light intensity of the LED labeled PTC1 should vary as
the potentiometer is rotated.
Optionally, you may run the DEMOQE Logic Analyzer Application
available in the DEMOQE toolkit on the CD. This PC-based
application graphs the IN0 and IN1 signals on the DEMOQE
board. If both J11 jumpers are installed, IN0 shows PTC0 and IN1
shows PTC1. Push button PTA2 and turn the potentiometer to
change these signals. This application may also be found at:
DEMO9S08QE32 User Manual