PK-HCS08GB60 SofTec Microsystems SRL, PK-HCS08GB60 Datasheet - Page 32

• Manufacturer Part Number: PK-HCS08GB60
• Description: KIT STARTER USB FOR MC9S08GB60
• Manufacturer: SofTec Microsystems SRL
• Type: MCUr

Specifications of PK-HCS08GB60

• Contents: Board, Cable, Software, Datasheets and User Manual
• Silicon Manufacturer: Freescale
• Core Architecture: HCS08
• Kit Contents: Emulator/Programmer
• Mc9s08gb60 Evaluation Board: Silicon Family Name
• Silicon Core Number: MC9S08GB60
• Core Sub-architecture: HCS08
• Silicon Family Name: S08GB
• Rohs Compliant: No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• For Use With/related Products: Freescale MC9S08GB60 (USB)
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant, Contains lead / RoHS non-compliant
• Other names: 520-1014

DataBlaze Notes
§
§
§
§
§
§
The “Mass Erase” operation always blanks the device (even if the device is protected
or secured) and “unsecures” the device (the NVOPT FLASH register is programmed
with 0xFE).
The “Blank Check” operation doesn’t blank check the NVOPT FLASH register.
The “Program” operation automatically verifies the programmed data, by reading back
the programmed data and checking it against the buffer sent to the target device. The
“Verify” operation is much more secure (but slower), since it reads back the
programmed data and checks it against the data buffer present in the host PC.
In case of verifying error, please verify the value programmed to the FLASH
Options/Security Byte location. The bit 0 of this byte is always programmed to 0, so
any attempt to program it to 1 will cause a verifying error.
The “Read”, “Program” and “Verify” operations are performed (when possible) by
setting the target microcontroller’s FLL peripheral so that the maximum BDM
communication speed is achieved.
The FLASH location suggested by Motorola where to store the trimming value is
reserved by DataBlaze. DataBlaze automatically calculates the trimming value and
writes it to that location.
PK-HCS08GB60 User's Manual
Page 31
4