STEVAL-MKI031V1 STMicroelectronics, STEVAL-MKI031V1 Datasheet - Page 34

• Manufacturer Part Number: STEVAL-MKI031V1
• Description: PLATFORM MUSA
• Manufacturer: STMicroelectronics

Specifications of STEVAL-MKI031V1

• Sensor Type: *
• Sensing Range: *
• Interface: *
• Sensitivity: *
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: *
• Voltage - Supply: *
• Sensing Axis: Double Axis
• Output Type: Digital
• Interface Type: USB
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: LPR5xxxAL, LPY5xxxAL, LY5xxxAL
• Other names: 497-10672

STM32-MEMS development kit
7.5.2
34/42
Figure 19. MEMS USB Reader Windows GUI application
STM32-MEMS LCD demonstration applications
The STM32-MEMS LCD demonstration applications read data from the MEMS sensor and
display it on the LCD mounted on the STM32 demonstration board. When a digital MEMS
with double-click detection is attached (for example, LIS302DL) the demonstration
applications utilize an interrupt generated by the MEMS and show a message on the LCD
when the double-click event occurs.
It is possible to use any of the compatible MEMS demonstration boards (see list in previous
section) without changing the firmware. However, do not forget to change the jumper
settings on the STM32-MEMS demonstration board if needed (for example, when changing
from an analog MEMS to a digital one).
Follow these steps to run the demonstration application.
1.
2.
3.
Mount the STM32-MEMS demonstration board onto the STM32 demonstration board
and mount the MEMS demonstration board onto the STM32-MEMS demonstration
board.
Correctly set-up the jumpers on the STM32-MEMS demonstration board. Do not forget
to position the JP10 jumper and set-up the board for use with the INT1 signal if needed.
Compile, flash and run the project corresponding to your STM32 demonstration board.
Doc ID 15703 Rev 1
UM0701