STEVAL-MKI090V1 STMicroelectronics, STEVAL-MKI090V1 Datasheet - Page 11

• Manufacturer Part Number: STEVAL-MKI090V1
• Description: DEMO BOARD FOR LIS331DLF
• Manufacturer: STMicroelectronics
• Series: MEMS, nanor

Specifications of STEVAL-MKI090V1

• Sensor Type: Accelerometer, 3 Axis
• Sensing Range: ±2g, 4g, 8g
• Interface: I²C, SPI
• Sensitivity: 16LSB/g, 8LSB/g, 4LSB/g
• Embedded: No
• Utilized Ic / Part: LIS331DLF
• Acceleration: 2 g, 4 g, 8 g
• Sensing Axis: Triple Axis
• Interface Type: I2C, SPI
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Voltage - Supply: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: LIS331DLF
• Other names: 497-10492

UM0701
5.1.4
The CN13-4-pin of the STM3210B-EVAL is also used by the Tamper button. The Tamper
button cannot be used when using the Int2 signal.
Figure 7.
Setup for digital MEMS - I
Position the JP7 and JP12 jumpers on the STM32-MEMS board.
If Int1 signal is used
Position the JP10 jumper on the STM32-MEMS board.
The CN13-14-pin of the STM3210B-EVAL is also used by the right joystick. If the joystick is
required, remove R75 from the STM3210B-EVAL board.
If Int2 signal is used
Position the JP11 jumper on the STM32-MEMS board.
The CN13-4-pin of the STM3210B-EVAL is also used by the Tamper button. The Tamper
button cannot be used when using the Int2 signal.
Figure 8.
Setup for digital MEMS - SPI interface
Setup for digital MEMS - I
Doc ID 15703 Rev 1
2
C interface
2
C interface
System setup
11/42