STEVAL-MKI077V1 STMicroelectronics, STEVAL-MKI077V1 Datasheet - Page 33

• Manufacturer Part Number: STEVAL-MKI077V1
• Description: BOARD DEMO LPR4150AL GYROSCOPE
• Manufacturer: STMicroelectronics
• Series: MEMSr

Specifications of STEVAL-MKI077V1

• Design Resources: STEVAL-MKI077V1 Schematic
• Sensor Type: Gyroscope, 2 Axis
• Sensing Range: ±1500°/sec
• Interface: Analog and Digital
• Sensitivity: 0.67mV/°/s
• Voltage - Supply: 5V, USB
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: LPR4150AL
• Sensing Axis: Double Axis
• Output Type: Analog, Digital
• Interface Type: USB
• Operating Voltage: 5 V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: LPR4150AL
• Other names: 497-10595

UM0701
7.5.1
Note:
STM32-MEMS USB demonstration application
The STM32-MEMS USB demonstration application reads data from the MEMS sensor and
sends it over USB to a PC. On the PC side runs the MEMS USB Reader (Windows GUI
application), which use an HID class of USB interface to receive data sent by the
demonstration application.
It is possible to use any of the compatible MEMS demonstration boards (see list in previous
section) without changing the firmware. However, do not forget to change the jumper
settings on the STM32-MEMS demonstration board if needed (for example, when changing
from an analog MEMS to a digital one).
Follow these steps to run the demonstration application.
1.
2.
3.
4.
5.
6.
In most cases it is necessary to power-down and power-up the system after flashing the
STM32 MCU before plugging it to a PC.
Figure 19
Mount the STM32-MEMS demonstration board onto the STM32 demonstration board
and mount the MEMS demonstration board onto the STM32-MEMS demonstration
board.
Correctly set-up the jumpers on the STM32-MEMS demonstration board.
Go to the IAR EWARM IDE in Project/Options/General Options and select the device
corresponding to the one used on your STM32 demonstration board (either ST
STM32F10xxB or ST STM32F10xxE).
In the stm32_mems_adapter.h file uncomment one line corresponding to the STM32
demonstration board used.
Compile, flash and run the project.
Run the MEMS USB Reader on the PC.
shows the MEMS USB Reader Windows GUI application.
Doc ID 15703 Rev 1
STM32-MEMS development kit
33/42