STEVAL-MKI082V1 STMicroelectronics, STEVAL-MKI082V1 Datasheet - Page 11

• Manufacturer Part Number: STEVAL-MKI082V1
• Description: BOARD ADAPTER LPY4150AL DIL24
• Manufacturer: STMicroelectronics
• Series: MEMSr

Specifications of STEVAL-MKI082V1

• Sensor Type: Gyroscope, 2 Axis
• Sensing Range: ±1500°/sec
• Interface: Analog
• Sensitivity: 0.67mV/°/s
• Voltage - Supply: 5V, USB
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: LPY4150AL
• Sensing Axis: Double Axis
• Output Type: Analog, Digital
• Interface Type: USB
• Operating Voltage: 5 V
• For Use With: 497-10682 - MOTEHRBOARD MEMS ADAPTER STM32
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: LPY4150AL
• Other names: 497-10598

UM0701
5.1.4
The CN13-4-pin of the STM3210B-EVAL is also used by the Tamper button. The Tamper
button cannot be used when using the Int2 signal.
Figure 7.
Setup for digital MEMS - I
Position the JP7 and JP12 jumpers on the STM32-MEMS board.
If Int1 signal is used
Position the JP10 jumper on the STM32-MEMS board.
The CN13-14-pin of the STM3210B-EVAL is also used by the right joystick. If the joystick is
required, remove R75 from the STM3210B-EVAL board.
If Int2 signal is used
Position the JP11 jumper on the STM32-MEMS board.
The CN13-4-pin of the STM3210B-EVAL is also used by the Tamper button. The Tamper
button cannot be used when using the Int2 signal.
Figure 8.
Setup for digital MEMS - SPI interface
Setup for digital MEMS - I
Doc ID 15703 Rev 1
2
C interface
2
C interface
System setup
11/42