STEVAL-ISA045V1 STMicroelectronics, STEVAL-ISA045V1 Datasheet - Page 12

• Manufacturer Part Number: STEVAL-ISA045V1
• Description: BOARD EVAL BASED ON ST1S09
• Manufacturer: STMicroelectronics
• Type: DC/DC Switching Converters, Regulators & Controllersr

Specifications of STEVAL-ISA045V1

• Design Resources: STEVAL-ISA045V1 Gerber Files STEVAL-ISA045V1 Schematic STEVAL-ISA045V1 Bill of Material
• Main Purpose: DC/DC, Step Down
• Outputs And Type: 1, Non-Isolated
• Voltage - Output: 1.2V
• Current - Output: 2A
• Voltage - Input: 2.7 ~ 5.5 V
• Regulator Topology: Buck
• Frequency - Switching: 1.5MHz
• Board Type: Fully Populated
• Utilized Ic / Part: ST1S09
• Input Voltage: 2.7 V to 5.5 V
• Output Voltage: 1.2 V
• Product: Power Management Modules
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Power - Output: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: ST1S09
• Other names: 497-6370

Application information
7
12/18
Application information
The ST1S09 is an adjustable current mode PWM step-down DC-DC converter with internal
2 A power switch, packaged in a DFN6 3 x 3 mm.
The device is a complete 2 A switching regulator with its internal compensation eliminating
the need for additional components.
The constant frequency, current mode, PWM architecture and stable operation with ceramic
capacitors results in low, predictable output ripple.
The over-voltage protection circuit acts when the output voltage is over 10 % of the rated
voltage and within 200 ns the low side MOSFET will be turned on to clamp the output
transient. The current limit for clamping is about 400 mA. When the output voltage drops to
about 5 % above the nominal level, the device returns to nominal closed loop switching
operation.
The open drain Power Good (PG) pin is released when the output voltage is higher than
0.92 x V
Other circuits fitted to the device protection are the thermal shut-down block, which turns off
the regulator when the junction temperature exceeds 150 °C (typ), and the cycle-by-cycle
current limiting, which provides protection against shorted outputs.
As an adjustable regulator, the ST1S09’s output voltage is determined by an external
resistor divider. The desired value is given by the following equation:
Equation 1
V
To utilize the device, only a few components are required: an inductor, two capacitors and
the resistor divider. The inductor chosen must be able to reach peak current level without
saturating. Its value can be selected while taking into account that a large inductor value
increases the efficiency at low output current and reduces output voltage ripple, while a
smaller inductor can be chosen when it is important to reduce package size and the total
cost of the application. Finally, the ST1S09 has been designed to work properly with X5R or
X7R SMD ceramic capacitors both at the input and at the output. These types of capacitors,
due to their very low series resistance (ESR), minimize the output voltage ripple. Other low
ESR capacitors can be used according to the need of the application without compromising
the correct functioning of the device.
O
= V
FB
O_NOM
[1 + R
. If the output voltage is below 0.92 x V
1
/ R
2
]
Doc ID 13632 Rev 4
O
, the PG pin goes to low impedance.
ST1S09