STEVAL-ILH001V1 STMicroelectronics, STEVAL-ILH001V1 Datasheet - Page 15

• Manufacturer Part Number: STEVAL-ILH001V1
• Description: BOARD STF20NM50FD/STF7LITE39BF2
• Manufacturer: STMicroelectronics

Specifications of STEVAL-ILH001V1

• Design Resources: STEVAL-ILH001V1 Gerber Files STEVAL-ILH001V1 Schematic STEVAL-ILH001V1 Bill of Material
• Main Purpose: Lighting, Ballast Control
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: L6562, ST7FLITE39F2
• Primary Attributes: 250W for HID Metal Halide Lamps
• Secondary Attributes: PFC, 90 ~ 265 VAC, MCU Based
• Product: Power Management Modules
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 497-8406

LIS331DLF
3
3.1
3.2
3.3
Functionality
The LIS331DLF is a “nano”, low-power, digital output 3-axis linear accelerometer packaged
in a LGA package. The complete device includes a sensing element and an IC interface
able to take the information from the sensing element and to provide a signal to the external
world through an I
Sensing element
A proprietary process is used to create a surface micro-machined accelerometer. The
technology allows to carry out suspended silicon structures which are attached to the
substrate in a few points called anchors and are free to move in the direction of the sensed
acceleration. To be compatible with the traditional packaging techniques a cap is placed on
top of the sensing element to avoid blocking the moving parts during the moulding phase of
the plastic encapsulation.
When an acceleration is applied to the sensor the proof mass displaces from its nominal
position, causing an imbalance in the capacitive half-bridge. This imbalance is measured
using charge integration in response to a voltage pulse applied to the capacitor.
At steady state the nominal value of the capacitors are few pF and when an acceleration is
applied the maximum variation of the capacitive load is in the fF range.
IC interface
The complete measurement chain is composed by a low-noise capacitive amplifier which
converts the capacitive unbalancing of the MEMS sensor into an analog voltage that is
finally available to the user by an analog-to-digital converter.
The acceleration data may be accessed through an I
device particularly suitable for direct interfacing with a microcontroller.
The LIS331DLF features a data-ready signal (RDY) which indicates when a new set of
measured acceleration data is available thus simplifying data synchronization in the digital
system that uses the device.
The LIS331DLF may also be configured to generate an inertial wake-up and free-fall
interrupt signal accordingly to a programmed acceleration event along the enabled axes.
Both Free-Fall and Wake-Up can be available simultaneously on two different pins.
Factory calibration
The IC interface is factory calibrated for sensitivity (So) and Zero-g level (TyOff).
The trimming values are stored inside the device in a non volatile memory. Any time the
device is turned on, the trimming parameters are downloaded into the registers to be used
during the active operation. This allows to use the device without further calibration.
2
C/SPI serial interface.
Doc ID 15101 Rev 4
2
C/SPI interface thus making the
Functionality
15/38