S82Y-VS10S Omron, S82Y-VS10S Datasheet - Page 20

• Manufacturer Part Number: S82Y-VS10S
• Description: MNTNG BRKT SIDE FOR S8VM60/90/12
• Manufacturer: Omron
• Series: S8VSr

Specifications of S82Y-VS10S

• Accessory Type: Mounting Bracket(s)
• For Use With/related Products: S8VS 60W, 90W, 120W Power Supplies
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: S82YVS10S

Self-Diagnostics Function
Numbers in the following table indicate the number used in Nomenclature on pages 14 and 17.
Note: 1. External noise is probable as a cause of “
(6) Main display
e04,
e05
---
h\t
e01
e02
e03
2. Operation out of the derating curve area, ventilation error, and incorrect mounting direction are probable as a cause of “
3. If the “
4. The “
(Maintenance forecast output terminal (Yrs)) will remain OFF (no continuity).
Replace the power supply if this condition occurs even if the output is correct, as internal parts may be deteriorated.
h\t
h\t
” error detection function is only for the S8VS-@@@24A@@.
Noise detected in voltage or
current
Overheated
Undervoltage alarm set value
memory error
Memory error of alarm set value
of maintenance forecast monitor
or total run time monitor
Other memory error
Hardware error
(S8VS-48024A/B only)
” error state continues for more than three hours, the maintenance forecast monitor function becomes invalid. The Yrs output
Description
---
No change
Maintenance
forecast output
terminal (Yrs) turns
OFF.
Undervoltage
output terminal (DC
LOW) turns OFF.
Maintenance
forecast output
terminal (Yrs) turns
OFF or total run
time output terminal
(kh) turns OFF.
Undervoltage
output terminal (DC
LOW) turns OFF.
Maintenance
forecast output
terminal (Yrs) turns
OFF or total run
time output terminal
(kh) turns OFF.
Undervoltage
output terminal (DC
LOW) turns OFF.
Maintenance
forecast output
terminal (Yrs) turns
OFF or total run
time output terminal
(kh) turns OFF.
”, “
Output status
e01
”, “
e02
”, “
e03
Automatic reset.
Automatic reset.
Press and hold the Up Key U (9) or Down
Key D (10) for three seconds and check
the set value of the corresponding point.
The set value must return to the shipment
setting
Turn the AC input OFF then ON again.
If the Product is not reset, contact the
dealer.
Turns the AC input OFF then ON again.
If the Product is not reset, contact the
dealer.
”, “
e04
”, and “
Restoration method
e05
” errors.
No change
No change
Shipment setting or
value set in the
setting mode again
No change
No change
Setting after
restoration
h\t
” error.
S8VS
20