MPDTY025S Murata Electronics North America, MPDTY025S Datasheet - Page 8

• Manufacturer Part Number: MPDTY025S
• Description: CONV DC/DC 12W 2.0VOUT 6A SIP
• Manufacturer: Murata Electronics North America
• Series: MPDr
• Type: Point of Load (POL) Non-Isolated with UVLOr

Specifications of MPDTY025S

• Output: 2V
• Number Of Outputs: 1
• Power (watts): 12W
• Mounting Type: Through Hole
• Voltage - Input: 4 ~ 5.5V
• Package / Case: 12-SIP Module
• 1st Output: 2 VDC @ 6A
• Size / Dimension: 1.30" L x 0.23" W x 0.94" H (33mm x 5.8mm x 24mm)
• Power (watts) - Rated: 12W
• Operating Temperature: -40°C ~ 85°C
• Efficiency: 93%
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• 3rd Output: -
• 2nd Output: -
• Other names: 490-4555

1. This datasheet is downloaded from the website of Murata Manufacturing co., ltd. Therefore, it’ s specifications are subject to change or our
2. This datasheet has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product
Note:
products in it may be discontinued without advance notice. Please check with our sales representatives or product engineers before ordering.
specifications or transact the approval sheet for product specifications before ordering.
9.2.4. Remote On/Off Control
9.2.5. Alarm Output (ALM)
9.2.6. Synchronous Turn-on/off
The connection to a RC pin controls an Isolated DC-DC Converter to turn on/off.
While the Isolated DC-DC Converter is halted under the remote control, alarm function does not
operate;refer to Alarm Output.
The Alarm Output can be down to the level of -Vin (Open Drain Output), when Over Voltage Protection or
Low Voltage Protection operates. Sink current in ALM pin is 10mA max. The Isolated DC-DC Converter
running for multiple and/or parallel operation are enable to simultaneously halt by connecting all ALM
pins, in the case of Over Voltage Protection or Low Voltage Protection caused by any single DC-DC
Converter.
To connect more than 10,please consult Murata.
The Isolated DC-DC Converters running for multiple and / or parallel operation are enable to synchronize
turn-on/off timing among the running converters, of which the input voltage detection circuits are unified
to the detection voltage of a certain Isolated DC-DC Converter. Every PO pin is necessary to be
connected for multiple and/or parallel operation. Maximum number running DC-DC Converters is 10pcs.
To connect more than 10,please consult Murata.
Start
Halt
Maximum number running DC-DC Converters is 10pcs.
: RC is open or connected to -Vin
: RC is connected to +Vin
MPD6D12*S Specification
2010.5.7
8