88-00151-85 Murata Wireless Solutions, 88-00151-85 Datasheet - Page 25

• Manufacturer Part Number: 88-00151-85
• Description: WiFi / 802.11 Development Tools Wi-FiNetworkControlr Module EVAL Kit
• Manufacturer: Murata Wireless Solutions

Specifications of 88-00151-85

• Rohs: yes
• Product: Development Kits
• Tool Is For Evaluation Of: 88-00151-00
• Protocol Supported: 802.11 b/g/n
• Frequency: 2.4 GHz
• Interface Type: I2C, SPI, UART
• Operating Supply Voltage: 3.3 V
• Part # Aliases: 88-00151-95

This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures: reorient or relocate the receiving antenna, increase the separation between the equipment
and receiver, connect the equipment into an outlet on a circuit different from that to which the
receiver is connected, or consult the dealer or an experienced radio/TV technician for help.
When integrating the SN8200 into a product the FCC labeling requirements must be met. This
includes a clearly visible label on the outside of the finished product specifying the SN8200 FCC
identifier (FCC ID:QPU8200) as well as the notice above. The exterior label can use wording such
as “Contains Transmitter Module FCC ID:QPU8200” or “Contains FCC ID:QPU8200” although
any similar wording that expresses the same meaning may be used.
This module has been certified for remote and base radio applications and is not intended to be
operated within 20cm of the body. If the module will be used for portable applications, the device
must undergo SAR testing.
The following statement must be included as a CAUTION statement in manuals for the products to
alert users on FCC RF exposure compliance:
“WARNING: To satisfy FCC RF exposure requirements for mobile transmitting devices, a
separation distance of 20cm or more should be maintained between the antenna of this device and
persons during operation. To ensure compliance, operations at closer distances than this are not
recommended.”
The term “IC” before the certification/registration number only signifies that the Industry Canada
technical specifications were met.
Le terme “IC” devant le numéro de certification /d’enregistrement signifie seulement que les
spécifications techniques Industrie Canada ont été respectées.
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to
The following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
11.2 FCC Labeling Requirements
11.3 RF Exposure
11.4 IC Notice (Canada)
Page 25 of 29
SN8200 User Manual and Datasheet v1.1