M24M01-DFMN6TP STMicroelectronics, M24M01-DFMN6TP Datasheet - Page 8

• Manufacturer Part Number: M24M01-DFMN6TP
• Description: EEPROM 1-Mbit I2C EEProm 256kB 1.7V to 5.5V
• Manufacturer: STMicroelectronics

Specifications of M24M01-DFMN6TP

• Rohs: yes

Signal description
2
2.1
2.2
2.3
2.4
2.5
8/38
Signal description
Serial Clock (SCL)
The signal applied on the SCL input is used to strobe the data available on SDA(in) and to
output the data on SDA(out).
Serial Data (SDA)
SDA is an input/output used to transfer data in or data out of the device. SDA(out) is an open
drain output that may be wire-OR’ed with other open drain or open collector signals on the
bus. A pull-up resistor must be connected
the pull-up resistor).
Chip Enable (E1, E2)
These input signals are used to set the value that is to be looked for on the two bits (b3, b2)
of the 7-bit device select code. These inputs must be tied to V
device select code as shown in
are read as low (0,0).
Figure 4.
Write Control (WC)
This input signal is useful for protecting the entire contents of the memory from inadvertent
write operations. Write operations are disabled to the entire memory array when Write
Control (WC) is driven high. Write operations are enabled when Write Control (WC) is either
driven low or left floating.
When Write Control (WC) is driven high, device select and address bytes are
acknowledged, Data bytes are not acknowledged.
V
V
SS
SS
is the reference for the V
(ground)
Device select code
CC
Doc ID 12943 Rev 10
Figure
supply voltage.
E i
M24xxx
V CC
V SS
4. When not connected (left floating), these inputs
(Figure 12
E i
M24xxx
V CC
V SS
indicates how to calculate the value of
Ai12806
CC
or V
M24M01-R M24M01-DF
SS
, to establish the