RN171XVW-I/RM Roving Networks, RN171XVW-I/RM Datasheet - Page 6

• Manufacturer Part Number: RN171XVW-I/RM
• Description: WiFi / 802.11 Modules WIFI MOD FOR EXISTNG 802.15.4 w/ Wire Ant
• Manufacturer: Roving Networks

Specifications of RN171XVW-I/RM

• Rohs: yes
• Protocol Supported: 802.11 b/g
• Frequency Band: 2.4 GHz
• Data Rate: 11 Mbps, 54 Mbps
• Interface Type: UART
• Transmit Power (max): 12 dBm
• Antenna Connector Type: Wire
• Operating Supply Voltage: 3.3 V
• Supply Current Transmitting: 180 mA
• Supply Current Receiving: 40 mA
• Maximum Operating Temperature: + 85 C
• Dimensions: 34.29 mm x 24.38 mm
• Minimum Operating Temperature: - 40 C
• Modulation Technique: DSSS, OFDM
• Security: WEP, WPA, WPA2

Design Concerns
Ordering Information
Roving Networks reserves the right to make corrections, modifications, and other changes to its products,
documentation and services at any time. Customers should obtain the latest relevant information before placing
orders and should verify that such information is current and complete.
Roving Networks assumes no liability for applications assistance or customer product design. Customers are
responsible for their products and applications using Roving Networks components. To minimize the risks associated
with customer products and applications, customers should provide adequate design and operating safeguards.
Roving Networks products are not authorized for use in safety-critical applications (such as life support) where a
failure of the Roving Networks product would reasonably be expected to cause severe personal injury or death,
unless officers of the parties have executed an agreement specifically governing such use.
All other trademarks are property of their respective owners.
1. Powering the RN-XV module: Apply ONLY 3.3V±10% regulated power to pin 1 (VDD) and pin 10 (Ground).
2. Antenna: The RN-XV ships with a wire antenna. Custom antenna configurations such as chip, U.FL. and
Part Number
RN-XV-W
RN-XV-U
RN-XV-C
RN-XV-S
www.rovingnetworks.com
The module does not have any voltage regulator on board and hence MUST be powered from a regulated
3.3V power supply.
SMA connector are available with extended lead times
809 University Avenue
Standard configuration, industrial Temperature (- 40 to + 85 C) 802.15.4 replacement
solution with ¼ inch wire antenna
Custom configuration, industrial Temperature (- 40 to + 85 C) 802.15.4 replacement solution
with U.FL. connector
Custom configuration, industrial Temperature (- 40 to + 85 C) 802.15.4 replacement solution
with SMA connector
Custom configuration, industrial Temperature (- 40 to + 85 C) 802.15.4 replacement solution
with chip antenna
Copyright © 2011 Roving Networks. All rights reserved.
•
Los Gatos, CA 95032
~ page 6 ~
•
Tel [phone]
RN-XV Data Sheet
Description
• [e-mail]
RN-XV-DS v0.3 8/18/2011