RN131C/RM Roving Networks, RN131C/RM Datasheet - Page 14

• Manufacturer Part Number: RN131C/RM
• Description: WiFi / 802.11 Modules WiFly GSX 802.11b/g Mod Commercial Temp
• Manufacturer: Roving Networks

Specifications of RN131C/RM

• Product Category: WiFi / 802.11 Modules
• Rohs: yes
• Protocol Supported: 802.11 b/g
• Frequency Band: 2.4 GHz
• Data Rate: 11 Mbps, 54 Mbps
• Interface Type: SPI, UART
• Transmit Power (max): 18 dBm
• Antenna Connector Type: Chip, U.FL
• Operating Supply Voltage: 3.3 V
• Supply Current Transmitting: 210 mA
• Supply Current Receiving: 40 mA
• Maximum Operating Temperature: + 70 C
• Dimensions: 38 mm x 20 mm x 4 mm
• Minimum Operating Temperature: 0 C
• Modulation Technique: DSSS, OFDM
• Security: WEP, WPA, WPA2

COMPLIANCE INFORMATION
The following sections describe the module’s FCC and NCC compliance information.
FCC Compliance
This equipment has been tested and found to comply with the limits for a Class digital device, pursuant to Part 15 of the
FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to the radio communications. However, there are no
guarantees that interference will not occur in a particular installation.
Troubleshooting
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following instructions
Conditions
Operation is subject to the following conditions
Markings
To satisfy the FCC exterior labeling requirements the following text must be placed on the exterior of the end product.
Contains Module FCC ID: U30-G2M5477
This marking applies to the G2M5477 and the RN-131 module, which are the same. Any similar working that expresses
the same meaning may be used.
FCC Warning
Modifications
Modifications not expressly approved by the manufacturer could void the user’s authority to operate the equipment under
FCC rules. See Table 7.
www.rovingnetworks.com
•
•
•
•
•
•
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment to an outlet or a circuit difference from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician.
This device may not cause harmful interference.
This device must accept any interference received, including interference that may cause undesired operation.
Version 3.2r 4/9/2012
RN -13 1-DS
14