ADS-917MM-C Murata, ADS-917MM-C Datasheet - Page 5

no-image

ADS-917MM-C

Manufacturer Part Number
ADS-917MM-C
Description
0 to +10v input range, no pipeline delay, -55 c to +125 c temperature range, rohs compliant....
Manufacturer
Murata
Datasheet
DATEL
THERMAL REQUIREMENTS
All DATEL sampling A/D converters are fully characterized and speci-
fi ed over operating temperature (case) ranges of 0 to +70°C and –55
to +125°C. All room-temperature (TA = +25°C) production testing is
performed without the use of heat sinks or forced-air cooling. Thermal
impedance fi gures for each device are listed in their respective specifi ca-
tion tables.
These devices do not normally require heat sinks, however, standard
precautionary design and layout procedures should be used to ensure
®
INTERNAL S/H
CONVERT
OUTPUT
START
DATA
EOC
Notes: 1. f
Data (N – 1) Valid
2. The ADS-917 is an edge-triggered device. All internal operations
200ns
926ns min.
typ.
N
are triggered by the rising edge of the start convert pulse, which
may be as narrow as 20nsec. All production testing is performed
at a 1MHz sampling rate with 200nsec wide start pulses. For
lower sampling rates, wider start pulses may be used, however, a
minimum pulse width low of 20nsec must be maintained.
s
430ns typ.
Conversion Time
= 500kHz.
Hold
420ns ±20ns
10ns typ.
®
90ns typ.
• 11 Cabot Boulevard, Mansfi eld, MA 02048-1151 USA • Tel: (508) 339-3000 • www.datel.com • e-mail: help@datel.com
Invalid
Data
Figure 4. ADS-917 Timing Diagram
Acquisition Time
570ns ±40ns
70ns ±10ns
35ns max.
74ns max.
Data N Valid
926ns min.
devices do not overheat. The ground and power planes beneath the package,
as well as all pcb signal runs to and from the device, should be as heavy as
possible to help conduct heat away from the package.
Electrically-insulating, thermally-conductive "pads" may be installed
underneath the package. Devices should be soldered to boards rather than
"socketed," and of course, minimal air fl ow over the surface can greatly help
reduce the package temperature.
14-Bit, 1MHz, Low-Power Sampling A/D Converters
N+1
Invalid
Data
01 Apr 2011 MDA_ADS-917.B02 Page 5 of 8
ADS-917

Related parts for ADS-917MM-C