ACE24C02ADP+TH ACE [ACE Technology Co., LTD.], ACE24C02ADP+TH Datasheet - Page 8

• Manufacturer Part Number: ACE24C02ADP+TH
• Description: Two-wire Serial EEPROM
• Manufacturer: ACE [ACE Technology Co., LTD.]

Write Operations
Byte Write:
acknowledgment. Upon receipt of this address, the EEPROM will again respond with a zero and then
clock in the first 8-bit data word. Following receipt of the 8-bit data word, the EEPROM will output a
zero and the addressing device, such as a microcontroller, must terminate the write sequence with a
stop condition. At this time the EEPROM enters an internally timed write cycle, t
memory. All inputs are disabled during this write cycle and the EEPROM will not respond until the write
is complete (refer to Figure 8).
Page Write:
condition after the first data word is clocked in. Instead, after the EEPROM acknowledges receipt of the
first data word, the microcontroller can transmit up to seven more data words. The EEPROM will
respond with a zero after each data word received. The microcontroller must terminate the page write
sequence with a stop condition (refer to Figure 9).
word. The higher data word address bits are not incremented, retaining the memory page row location.
When the word address, internally generated, reaches the page boundary, the following byte is placed
at the beginning of the same page. If more than eight data words are transmitted to the EEPROM, the
data word address will “roll over” and previous data will be overwritten.
Acknowledge Polling:
polling can be initiated. This involves sending a start condition followed by the device address word.
The read/write bit is representative of the operation desired. Only if the internal write cycle has
completed will the EEPROM respond with a zero allowing the read or write sequence to continue.
Read Operations
select bit in the device address word is set to one. There are three read operations: current address
read, random address read and sequential read.
Current Address Read:
write operation, incremented by one. This address stays valid between operations as long as the chip
power is maintained. The address “roll over” during read is from the last byte of the last memory page
to the first byte of the first page. The address “roll over” during write is from the last byte of the current
page to the first byte of the same page.
the EEPROM, the current address data word is serially clocked out. The microcontroller does not
respond with an input zero but does generate a following stop condition (refer to Figure 10).
A write operation requires an 8-bit data word address following the device address word and
The 2K devices are capable of 8-byte page writes.
A page write is initiated the same as a byte write, but the microcontroller does not send a stop
The data word address lower three bits are internally incremented following the receipt of each data
Once the internally timed write cycle has started and the EEPROM inputs are disabled, acknowledge
Read operations are initiated the same way as write operations with the exception that the read/write
The internal data word address counter maintains the last address accessed during the last read or
Once the device address with the read/write select bit set to one is clocked in and acknowledged by
Technology
Two-wire Serial EEPROM
ACE24C02A
WR,
to the nonvolatile
VER 1.2
8