CX28344 Conexant, CX28344 Datasheet - Page 147

• Manufacturer Part Number: CX28344
• Description: (CX2834x) Dual / Triple / Quad / Hex / Octal - Enhanced DS3 / E3 Framer
• Manufacturer: Conexant

CX28342/3/4/6/8 Data Sheet
Value after reset: 00(h)
Direction: Read only
Value after enable: 00(h)
LOSEnd
IdleEnd
YelEnd
AISEnd
OOFEnd
28348-DSH-001-B
Reserved
7
Reserved
Loss of Signal Event End—Set when the received signal, prior to B3ZS/HDB3 decoding,
satisfies the criteria of correct signal after being in a loss-of-signal state. This bit is cleared
when this register is read.
Idle Event End—Set when the receiver detects an end of an Idle event in DS3 mode. This bit is
cleared when this register is read. This bit is low in E3 modes, because there is no defined E3
idle signal.
Yellow Alarm End—Set when the receiver detects the end of an RAI/RDI alarm. This bit is
cleared when this register is read.
AIS Alarm End—Set when the receiver detects the end of an AIS alarm. This bit is cleared
when this register is read.
Out of Frame Event End—Set when the channel goes into in-frame state again after being in
an OOF state. This bit is cleared when this register is read.
6
Alarm End Interrupt Status Register (SR04i)
Reserved
5
Mindspeed Technologies™
LOSEnd
4
IdleEnd
3
YelEnd
2
AISEnd
1
OOFEnd
0
Registers
3
-
35