HCS320_11 MICROCHIP [Microchip Technology], HCS320_11 Datasheet - Page 11

• Manufacturer Part Number: HCS320_11
• Manufacturer: MICROCHIP [Microchip Technology]

5.0
5.1
Code word completion is an automatic feature that
makes sure that the entire code word is transmitted,
even if the transmit button is released before the trans-
mission is complete. The HCS320 encoder powers
itself up when a button is pushed and powers itself
down after the command is finished, if the user has
already released the button. If the button is held down
beyond the time for one transmission, then multiple
transmissions will result. If another button is activated
during a transmission, the active transmission will be
aborted and the function new code will be generated
using the new button information.
5.2
The Auto-shutoff function automatically stops the
device from transmitting if a button inadvertently gets
pressed for a long period of time. This will prevent the
device from draining the battery if a button gets
pressed while the transmitter is in a pocket or purse.
This function can be enabled or disabled and is
selected by setting or clearing the Auto-shutoff bit
(Section 3.4.1). Setting this bit high will enable the
function (turn Auto-shutoff function on) and setting the
bit low will disable the function. Time-out period is
dependent on the shift level and is approximately 42
±10 seconds.
FIGURE 5-1:
© 2011 Microchip Technology Inc.
SPECIAL FEATURES
Code Word Completion
Auto-Shutoff
LEVEL
SHIFT
0
1
2
3
LED FLASH FUNCTION (EACH DIVISION - 180 MS)
LED OUTPUT
5.3
The V
(Figure 9-6) and will be transmitted as a one if the oper-
ating voltage has dropped below the low voltage trip
point. The trip point is selectable between two values,
based on the battery voltage being used. See
Section 3.5.4 for a description of how the low voltage
select option is set. This V
the receiver can alert the user that the transmitter bat-
tery is low.
5.4
This bit will be low for the first transmitted word. If a
button is held down for more than one transmitted code
word, this bit will be set to indicate a repeated code
word and remain set until the button is released.
5.5
During normal transmission the LED output (Figure 5-1)
indicates the shift level (Section 5.7) by flashing the
LED in a pattern corresponding to the shift level. If the
supply voltage drops below the low voltage trip point
(Section 3.5.4), the LED output will be toggled at
approximately 5 Hz during the transmission.
Note:
LOW
VLOW: Voltage LOW Indicator
RPT: Repeat Indicator
LED Output Operation
Depending on the internal resistance of the
V
the V
turned on. In this case, the V
transmitted as a one when a transmission
occurs while the LED is on. The V
will be transmitted as a zero when a trans-
mission occurs while the LED is off.
bit is transmitted with every transmission
DD
source, V
LOW
trip point except when the LED is
DD
LOW
may normally be above
signal is transmitted so
HCS320
DS41097D-page 11
LOW
bit will be
LOW
bit