M41T315V-65MH6F STMICROELECTRONICS [STMicroelectronics], M41T315V-65MH6F Datasheet - Page 16

• Manufacturer Part Number: M41T315V-65MH6F
• Description: Serial access phantom RTC supervisor
• Manufacturer: STMICROELECTRONICS [STMicroelectronics]

3
3.1
3.2
3.3
3.4
16/30
Clock operation
Clock register information
Clock information is contained in eight registers of 8 bits, each of which is sequentially
accessed 1 bit at a time after the 64-bit pattern recognition sequence has been completed.
When updating the clock registers, each must be handled in groups of 8 bits. Writing and
reading individual bits within a register could produce erroneous results. These
READ/WRITE registers are defined in
Data contained in the clock registers is in binary coded decimal format (BCD). Reading and
writing the registers is always accomplished by stepping though all eight registers, starting
with Bit 0 of Register 0 and ending with Bit 7 of Register 7.
AM-PM/12/24 mode
Bit 7 of the hours register is defined as the 12-hour or 24-hour mode select bit. When high,
the 12-hour mode is selected. In the 12-hour mode, Bit 5 is the AM/PM bit with logic high
being PM. In the 24-hour mode, Bit 5 is the second 10-hour bit (20-23 hours).
Oscillator and reset bits
Bits 4 and 5 of the day register are used to control the reset and oscillator functions. Bit 4
controls the reset pin input. When the Reset Bit is set to logic '1,' the reset input pin is
ignored. When the Reset Bit is set to logic '0,' a low input on the reset pin will cause the
device to abort data transfer without changing data in the timekeeping registers. Reset
operates independently of all other inputs. Bit 5 controls the oscillator. When set to logic '0,'
the oscillator turns on and the real-time clock/calendar begins to increment.
Zero bits
Registers 1, 2, 3, 4, 5, and 6 contain one (1) or more bits that will always read logic '0.' When
writing to these locations, either a logic '1' or '0' is acceptable.
Table 5 on page
17.