acpm-5008-tr1 Avago Technologies, acpm-5008-tr1 Datasheet - Page 6

• Manufacturer Part Number: acpm-5008-tr1
• Description: Av02-2480en Ds Acpm-5008 17dec2010.pdf
• Manufacturer: Avago Technologies

Metallization
0.35
Solder Mask Opening
Solder Paste Stencil Aperture
0.35
6
0.60
0.45
0.60
0.60
0.30
0.55
0.65
0.55
1.50
1.10
on 0.5mm pitch
Ø 0.3mm
connected to a inner layer
through a via hole for a
better isolation between
CPL_IN(ISO) and RFout
0.45
0.45
0.50
0.475
0.475
1.10
1.30
0.525
PCB Design Guidelines
The recommended PCB land pattern is shown in figures
on the left side. The substrate is coated with solder mask
between the I/O and conductive paddle to protect the
gold pads from short circuit that is caused by solder
bleeding/bridging.
Stencil Design Guidelines
A properly designed solder screen or stencil is required
to ensure optimum amount of solder paste is deposited
onto the PCB pads.
The recommended stencil layout is shown here. Reducing
the stencil opening can potentially generate more voids.
On the other hand, stencil openings larger than 100% will
lead to excessive solder paste smear or bridging across
the I/O pads or conductive paddle to adjacent I/O pads.
Considering the fact that solder paste thickness will
directly affect the quality of the solder joint, a good choice
is to use laser cut stencil composed of 0.100mm(4mils) or
0.127mm(5mils) thick stainless steel which is capable of
producing the required fine stencil outline.