CS2A100KC DBLECTRO [DB Lectro Inc], CS2A100KC Datasheet - Page 7
![no-image](/images/no-image-200.jpg)
CS2A100KC
Manufacturer Part Number
CS2A100KC
Description
CHIP TYPE, STANDARD
Manufacturer
DBLECTRO [DB Lectro Inc]
Datasheet
1.CS2A100KC.pdf
(13 pages)
DB LECTRO Inc. 3755 Place Java, Suite 140, Brossard, Québec, J4Y 0E4, Canada - T: 1-450-444-1424 / F: 1-450-444-4714 / www.dblectro.com
The following precautions must be observed when using electrolytic capacitors.
1. Circuit Design
1) Please make sure that the environmental and mounting conditions to which the capacitor to be
2) Operating temperature and applied ripple must be within the specifications.
3) Appropriate capacitors, which comply with the life requirement of the products, should be selected
4) Aluminum electrolytic capacitors are polarized. Do not apply reserve voltage or AC voltage. Please
5) Do not use aluminum electrolytic capacitors in a circuit that requires rapid and very frequent charge
6) Do not apply excess voltage.
7) Outer sleeved of the capacitor is not guarantee as an electrical insulator. Do not use standard sleeve
8) Capacitors must not be used under following conditions:
exposed are within the conditions specified in this catalogue.
when designing the circuit.
use non-polarized capacitors for a circuit that can possibly see reserved polarity.
Note: Non-polarizes capacitors cannot be used for AC voltage application.
or discharge. In this type of circuit, it is necessary to use special design capacitors with extended life
characteristics.
on a capacitor in applications that require electrical insulation. When the application requires special
insulation, please contact our sales office for details.
GENERAL INFORMATION FOR APPLICATION
Pleased pay attention so that the peak voltage, which is DC voltage overlapped by ripple current,
(a) Capacitors must not be exposed to water (including condensation), brine or oil.
(b) Ambient conditions that include toxic gases such as hydrogen sulfide, sulfurous acid, nitrous
(c) Ambient conditions that expose the capacitor to ozone, ultraviolet ray and radiation.
Severe vibration and physical shock conditions that exceed our specification.
In the case where more than two aluminum electrolytic capacitors are used in series, please
should not exceed the rated voltage.
make sure that applied voltage should be lower than rated voltage should be applied to each
capacitor equally using a balancing resistor in parallel with the capacitor.
Vibration test condition:
Shock is not applicable normally.
If a particular condition is required, please contact our sales office.
acid, chlorine, ammonium, etc.
Vibration frequency range: 10~55~10Hz
Sweet rate
Sweet method
Amplitude or acceleration: 1.5 (max. acceleration is 10G)
Direction of vibration
Testing time
: 10~55~10Hz per minute
: 2 hours per each direction
: X, Y, Z direction
: logarithmic