hw1b-m101y IDEC Corporation, hw1b-m101y Datasheet - Page 47

• Manufacturer Part Number: hw1b-m101y
• Description: Hw Series Control Units
• Manufacturer: IDEC Corporation

Tightening Torque for Terminal Screws
Tighten the M3.5 terminal screws to a torque of 1.0 to 1.3
N·m
Installation of LED Illuminated Units
1. When using full voltage type LED illuminated units, pro-
2. Notes for Pure White LED Lamps
• Do not use the pure white LED outdoors, otherwise it will
• Use a white lens. The illumination color will be dull if a dif-
Applicable Wiring
The applicable wire size is 2mm
mm max.) One or two wires can be connected.
• Applicable Crimping Terminal
Be sure to use an insulation tube or cover on the crimping
part of the crimping terminal to prevent electrical shocks.
• Solid Wire
Note: Contact Block and Transformer
lead to the degradation of brightness and color. Do not
remove or apply shock to the cap on the pure white LED
lamp, otherwise it may break or damage the cap.
ferent color lens is used.
Instructions
vide protection against electrical noise, if necessary.
.
When connecting wires in the direction shown below, keep
the insulation stripping length 6.6 mm at the maximum.
4 max.
2
ø3.6 min.
maximum. (Solid wire ø1.6
8 max.
5.5 min.
X1
X2
Anti-rotation Ring and Panel Cut-out
Align the TOP marking on the operator and the ▲ mark on
the anti-rotation ring with the recess in the mounting panel.
• Panel Cut-out
(Complies with IEC947-5-1)
Unibody Pushlock Turn Reset
• Removing the lens
Remove the lens by inserting a screwdriver into the left or
right recess of the lens. Be careful that the lens does not
drop off.
• Removing the LED/incandescent lamp
Use a lens removal tool to remove the lamp. See page 46
for more information.
• Notes for Wiring
Ensure that the crimping terminal of each wiring is properly
insulated.
Key Selector Switch
• Notes for using a different key
When a different number key is inserted into the key hole, it
will not normally operate. However, if the key is forced to
turn or is not inserted properly, it may be turned.
HW
HW Operator
Series
3.2
+0.2
0
Instructions
Anti-rotation
Ring
Projection
Mounting
Panel
Panel Thickness
1.2 to 4.5
Locking
Ring
ø22
47