tsl2301 TEXAS ADVANCED OPTOELECTRONIC SOLUTIONS, tsl2301 Datasheet - Page 7

• Manufacturer Part Number: tsl2301
• Description: Linear Optical Sensor Array With Analogtodigital Converter
• Manufacturer: TEXAS ADVANCED OPTOELECTRONIC SOLUTIONS

www.taosinc.com
Reset Commands
IRESET – Interface Initialization
RESET – Main Reset
Pixel Action Commands
STARTInt – Start Integration
SAMPLEInt – Stop Integration
READPixel – Read Pixel Data
Reset commands are used to put the TSL2301 into a known state.
Encoding: Break Character
IRESET initializes the internal state machine that keeps track of which command bytes have been received.
This command should be first and given only once after power-up to synchronize TSL2301’s command
interpreter.
Encoding: 0x1b: <0001_1011>
RESET resets most of the internal control logic of the TSL2301 and any READPixel command currently in
progress is aborted. RESET puts the pixel integrators into the auto-zero/reset state. Any values that were being
held in the array’s sample/hold circuits are lost.
Pixel action commands allow the user to control pixel integration and reading of pixel data.
Encoding: 0x08: <0000_1000>
STARTInt causes each pixel to leave the reset state and to start integrating. The actual execution of STARTInt
is delayed 20 clocks until the auto-zero cycle of the pixels has been completed.
Encoding: 0x10: <0001_0000>
SAMPLEInt causes each pixel to store its integrator’s contents into a sample and hold circuit. Also, the Integrator
is returned to the reset state.
Encoding: 0x02: <0000_0010>
READPixel causes the sampled value of each pixel to be converted to an 8-bit digital value that is clocked out
on the SDOUT pin. The LSB is the first data bit, which is preceded by a START bit (logic 0) and followed by a
STOP bit (logic 1). Each pixel in the device is presented on SDOUT starting from pixel 00 and completes with
pixel 101. It takes 20 clocks before the first pixel is available to be read and 10 clocks per pixel thereafter until
all pixels are output.
Gain and offset registers are used to adjust the ADC converter to maximize dynamic range and should be
programmed prior to invoking the READPixel command.
On power up of the TSL2301, it is necessary to hold SDIN high for 30 clocks before initiating a reset
command. In addition, to fully reset the device, it is recommended that 3 consecutive RESET
commands be issued as part of the power up routine.
The value on the SDOUT pin is not guaranteed from the time power is applied until 30 clocks after
the first RESET command is issued.
t
NOTE:
NOTE:
t
Copyright E 2000, TAOS Inc.
TAOS007 – JULY 2000
7