lm2612atlx National Semiconductor Corporation, lm2612atlx Datasheet - Page 5

• Manufacturer Part Number: lm2612atlx
• Description: Ic Conv Dc/dc Stp-dwn 10microsmd
• Manufacturer: National Semiconductor Corporation

f
F
T
sync
Electrical Characteristics
Specifications with standard typeface are for T
perature Range (T
0V.
OSC
min
Note 1: Absolute Maximum Ratings indicate limits beyond which damage to the device may occur. Operating Ratings are conditions for which the device is intended
to be functional, but parameter specifications may not be guaranteed. For guaranteed specifications and associated test conditions, see the Min and Max limits and
Conditions in the Electrical Characteristics table. Electrical Characteristics table limits are guaranteed by production testing, design or correlation using standard
Statistical Quality Control methods. Typical (Typ) specifications are mean or average values from characterization at 25˚C and are not guaranteed.
Note 2: Thermal shutdown will occur if the junction temperature exceeds the 150˚C maximum junction temperature of the device.
Note 3: Thermal resistance specified with 2 layer PCB(0.5/0.5 oz. cu).
Note 4: The LM2612 is designed for applications where turn-on after system power-up is controlled by the system processor and internal UVLO (Under Voltage
LockOut) circuitry is unnecessary. The LM2612 has no UVLO circuitry and should be kept in shutdown by holding the EN pin low until the input voltage exceeds 2.8V.
Although the LM2612 exhibits safe behavior while enabled at low input voltages, this is not guaranteed.
Note 5: The feedback voltage is trimmed at the 1.5V output setting. The other output voltages result from the pin selection of the internal DAC’s divider ratios. The
precision for the feedback voltages is
Note 6: : The hysteresis voltage is the minimum voltage swing on FB that causes the internal feedback and control circuitry to turn the internal PFET switch on and
then off during PFM mode.
Note 7: Current limit is built-in, fixed, and not adjustable. If the current limit is reached while the output is pulled below about 0.7V, the internal PFET switch turns
off for 2.5 µs to allow the inductor current to diminish.
Note 8: SYNC driven with an external clock switching between V
external clock frequency. The LM2612 synchronizes to the rising edge of the external clock.
Symbol
SYNC/MODE Clock
Frequency Range
(Note 8)
Internal Oscillator
Frequency
Minimum ON-Time of P FET
Switch in PWM Mode
A
= T
Parameter
J
= −25˚C to +85˚C). Unless otherwise specified, PVIN = VDD = EN = SYNC = 3.6V, VID0 = VID1 =
±
2%.
(Continued)
LM2612ABL/ATL, PWM Mode
(SYNC = VIN)
LM2612BBL/BTL, PWM Mode
(SYNC = VIN)
A
= T
IN
J
= 25˚C, and those in bold face type apply over the full Operating Tem-
and GND. When an external clock is present at SYNC, the IC is forced to PWM mode at the
Conditions
5
Min
500
468
450
Typ
600
600
200
1000
Max
732
750
www.national.com
Units
kHz
kHz
nS