cy8c42123 Cypress Semiconductor Corporation., cy8c42123 Datasheet - Page 4

• Manufacturer Part Number: cy8c42123
• Description: Power Psoc? Devices
• Manufacturer: Cypress Semiconductor Corporation.

4.6
The Analog Mux Bus can connect to every GPIO pin in ports
P0 and P1. Pins can be connected to the bus individually or
in any combination. The bus also connects to the analog sys-
tem for analysis with comparators and analog-to-digital con-
verters. This bus is split into four sections, AMux Bus 0 and
AMux Bus 2, which connect to the even port pins and AMux
Bus 1 and AMux Bus 3, which connect to the odd port pins.
The four sections can be combined to support dual-channel
single-end processing, single-channel differential processing,
or dual-channel differential processing. They can also be
connected as one bus that can route to all GPIO pins.
Other multiplexer applications include:
4.7
System Resources, some of which have been previously
listed, provide additional capability useful to complete systems
implemented in a single power block. Additional resources
include an I2C master and slave, low voltage detection, and
power on reset. Brief statements describing the merits of each
system resource are presented below.
Document 38-12034 Rev. *C
• Chip-wide mux that allows analog input from up to 10 GPIO
• Crosspoint connection between any GPIO pin combina-
• Digital clock dividers provide three customizable clock
• The I2C module provides 50-, 100-, and 400-kHz commu-
• Low Voltage Detection (LVD) interrupts can signal the appli-
• An internal 1.3 voltage reference provides an absolute
pins.
tions.
frequencies for use in applications. The clocks can be
routed to both the digital and analog systems. Additional
clocks can be generated using digital PSoC blocks as clock
dividers.
nication over two wires. Slave, master, and multi-master
modes are all supported.
cation of falling voltage levels, while the advanced POR
(Power On Reset) circuit eliminates the need for a system
supervisor.
reference for the analog system, including ADCs and DACs.
Analog Multiplexer System
Additional System Resources
PRELIMINARY
4.8
• Standard Cypress PSoC IDE tools are available for
• In-System Serial Programming (ISSP) is available.
debugging the CY8C42x23 family of parts. However, the
additional trace length and a minimal ground plane in the
Flex-Pod can create noise problems that make it difficult to
debug a Power PSoC design. A custom bonded On-Chip
Debug (OCD) device is available in an 32-pin QFN package.
The OCD device is recommended for debugging designs
that have high current and/or high analog accuracy require-
ments. The QFN package is compact and can be connected
to the ICE through a high density connector.
However, ISSP for Power PSoC differs from ISSP for
standard PSoC devices. With Power PSoC devices, the
power pin (HV
V
programming device.
dd
pin of the ISSP connector. Doing so can damage the
Development Tools
dd
) should not be connected directly to the
CY8C42123/CY8C42223
CY8C42323/CY8C42423
Page 4 of 42