sy56034ar Micrel Semiconductor, sy56034ar Datasheet - Page 7

• Manufacturer Part Number: sy56034ar
• Description: Low Voltage 1.2v/1.8v/2.5v 2 6 Mux With Crosspoint Capability 5ghz/6.4gbps
• Manufacturer: Micrel Semiconductor

Interface Applications
For Input Interface Applications, see Figures 4a
through 4f. For CML Output Termination, see Figures
5a through Figure 5d.
CML Output Termination with VCCO 1.2V
For VCCO of 1.2V, Figure 5a, terminate the output
with 50Ω-to-1.2V, DC coupled, not 100Ω differentially
across the outputs.
If AC-coupling is used, Figure 5d, terminate into 50Ω-
to-1.2V before the coupling capacitor and then
connect to a high value resistor to a reference
voltage.
Do not AC couple with internally terminated receiver.
For example, 50Ω ANY-IN input. AC-coupling will
offset the output voltage by 200mV and this offset
voltage will be too low for proper driver operation. Any
unused output pair needs to be terminated when
VCCO is 1.2V, do not leave floating.
Timing Diagrams
September 2008
Figure 1. Propagation Delay
7
CML Output Termination with VCCO 1.8V, 2.5V
For VCCO of 1.8V or 2.5V, Figure 5a and Figure 5b,
terminate
differentially across the outputs. AC- or DC-coupling
is fine. See Figure 5c for AC-coupling.
Input AC-Coupling
The SY56034AR input can accept AC-coupling from
any driver. Bypass VT with a 0.1µF low ESR capacitor
to VCC as shown in Figures 4c and 4d. VT has an
internal high impedance resistor divider as shown in
Figure 2a, to provide a bias voltage for AC-coupling.
with
[e-mail]
either
50Ω-to-1.8V
or [phone]
M9999-093008-A
or
100Ω