TC648B Microchip Technology Inc., TC648B Datasheet - Page 20

• Manufacturer Part Number: TC648B
• Description: Pwm Fan Speed Controllers With Auto-shutdown, Fan Restart And Fansense Technology For Fault Detection
• Manufacturer: Microchip Technology Inc.

TC646B/TC648B/TC649B
TABLE 5-1:
The values listed in Table 5-1 are for fans that have the
fan current waveshape shown in Figure 4-7. With this
waveshape, the average fan current is closer to the
peak value, which requires the resistor value to be
higher. When using a fan that has the fan current wave-
shape shown in Figure 4-6, the resistor value can often
be decreased since the current peaks are higher than
the average and it is the AC portion of the voltage that
gets coupled to the SENSE pin.
The key point when selecting an R
to minimize the value in order to minimize the power
dissipation in the resistor. In order to do this, it is critical
to know the waveshape of the fan current and not just
the average value.
Figure 5-4 shows some typical waveforms for the fan
current and the voltage at the SENSE pin.
FIGURE 5-4:
SENSE Pin Waveforms.
DS21755B-page 20
Nominal Fan Current
(mA)
100
150
200
250
300
350
400
450
500
50
FAN CURRENT VS. R
Typical Fan Current and
SENSE
R
SENSE
9.1
4.7
3.0
2.4
2.0
1.8
1.5
1.3
1.2
1.0
value is to try
( )
SENSE
Another important factor to consider when selecting the
R
rotor condition. When a fan is in a locked-rotor condi-
tion (fan blades are stopped even though power is
being applied to the fan), the fan current can increase
dramatically (often 2.5 to 3.0 times the normal operat-
ing fan current). This will effect the power rating of the
R
When selecting the fan for the application, the current
draw of the fan during a locked-rotor condition should
be considered. Especially if multiple fans are being
used in the application.
There are two main types of fan designs when looking
at fan current draw during a locked-rotor condition.
The first is a fan that will simply draw high DC currents
when put into a locked-rotor condition. Many older fans
were designed this way. An example of this is a fan that
draws an average current of 100 mA during normal
operation. In a locked-rotor condition, this fan will draw
250 mA of average current. For this design, the
R
250 mA condition. The fan bias supply must also take
this into account.
The second style design, which represents many of the
newer fan designs today, acts to limit the current in a
locked-rotor condition by going into a pulse mode of
operation. An example of the fan current waveshape
for this style fan is shown in Figure 5-5. The fan repre-
sented in Figure 5-5 is a Panasonic
During the on-time of the waveform, the fan current is
peaking up to 550 mA. Due to the pulse mode opera-
tion, the actual RMS current of the fan is very near the
220 mA rating. Because of this, the power rating for the
R
application.
SENSE
SENSE
SENSE
SENSE
value is the fan current value during a locked-
resistor selected.
resistor does not have to be oversized for this
power rating must be sized to handle the
2003 Microchip Technology Inc.
®
, 12V, 220 mA fan.