74HC7541D,112 NXP Semiconductors, 74HC7541D,112 Datasheet - Page 16

• Manufacturer Part Number: 74HC7541D,112
• Description: IC SCHMT TRIG BUFF/DVR 8B 20SOIC
• Manufacturer: NXP Semiconductors
• Series: 74HCr

Specifications of 74HC7541D,112

• Logic Type: Schmitt Trigger - Buffer, Driver
• Package / Case: 20-SOIC (7.5mm Width)
• Number Of Elements: 1
• Number Of Bits Per Element: 8
• Current - Output High, Low: 7.8mA, 7.8mA
• Voltage - Supply: 2 V ~ 6 V
• Operating Temperature: -40°C ~ 125°C
• Mounting Type: Surface Mount
• Logic Family: 74HC
• Number Of Channels Per Chip: 8
• Polarity: Non-Inverting
• Supply Voltage (max): 6 V
• Supply Voltage (min): 2 V
• Maximum Operating Temperature: 125 C
• Mounting Style: SMD/SMT
• High Level Output Current: - 7.8 mA
• Input Bias Current (max): 8 uA
• Low Level Output Current: 7.8 mA
• Maximum Power Dissipation: 500 mW
• Minimum Operating Temperature: - 40 C
• Number Of Lines (input / Output): 10 / 8
• Output Type: 3-State
• Propagation Delay Time: 36 ns
• Logical Function: Schmit Trig Buffer
• Number Of Elements: 1
• Number Of Channels: 8
• Number Of Inputs: 8
• Number Of Outputs: 8
• Operating Supply Voltage (typ): 5V
• Package Type: SO
• Operating Supply Voltage (max): 6V
• Operating Supply Voltage (min): 2V
• Quiescent Current: 8uA
• Technology: CMOS
• Pin Count: 20
• Mounting: Surface Mount
• Operating Temp Range: -40C to 125C
• Operating Temperature Classification: Automotive
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: 568-2742-5; 933967940112

Philips Semiconductors
HCMOS family characteristics
FAMILY SPECIFICATIONS
AC CHARACTERISTICS
The “AC CHARACTERISTICS” table lists the guaranteed
limits when a device is tested under the conditions given in
the AC Test Circuits and Waveforms section.
TEST CIRCUITS
Good high-frequency wiring practices should be used in
test circuits. Capacitor leads should be as short as
possible to minimize ripples on the output waveform
transitions and undershoot. Generous ground metal
(preferably a ground-plane) should be used for the same
reasons. A V
decoupling capacitor should be provided
CC
at the test socket, also with short leads. Input signals
should have rise and fall times of 6 ns, a signal swing of
0 V to V
for 74HC and 0 V to 3 V for 74HCT; a 1.0 MHz
CC
square wave is recommended for most propagation delay
tests. The repetition rate must be increased for testing
f
. Two pulse generators are usually required for testing
max
such parameters as set-up time, hold time and removal
time. f
is also tested with 6 ns input rise and fall times,
max
with a 50% duty factor, but for typical f
as high as
max
60 MHz, there are no constraints on rise and fall times.
March 1988
16