IR3081AMTR International Rectifier, IR3081AMTR Datasheet - Page 37

• Manufacturer Part Number: IR3081AMTR
• Description: XPHASE VR 10.0 Control IC. The Control IC combined with an IR XPhase TM Phase IC provides a full featured and flexible way to implement a complete VR 10.0 power solution.
• Manufacturer: International Rectifier

Specifications of IR3081AMTR

• Package: 28-Lead MLPQ
• Circuit: X-Phase Controller IC
• Switch Freq (khz): 150kHz to 1.0MHz
• Pbf: PbF Option Available

Stencil Design
• The stencil apertures for the lead lands should be approximately 80% of the area of the lead lands.
• The stencil lead land apertures should therefore be shortened in length by 80% and centered on the lead
• The land pad aperture should be striped with 0.25mm wide openings and spaces to deposit
• The maximum length and width of the land pad stencil aperture should be equal to the solder resist
Page 37 of 39
Reducing the amount of solder deposited will minimize the occurrence of lead shorts. Since for 0.5mm
pitch devices the leads are only 0.25mm wide, the stencil apertures should not be made narrower;
openings in stencils < 0.25mm wide are difficult to maintain repeatable solder release.
land.
approximately 50% area of solder on the center pad. If too much solder is deposited on the center pad
the part will float and the lead lands will be open.
opening minus an annular 0.2mm pull back to decrease the incidence of shorting the center land to the
lead lands when the part is pushed into the solder paste.
IR3081A
1/31
/05