AT89LP213 Atmel Corporation, AT89LP213 Datasheet - Page 19

• Manufacturer Part Number: AT89LP213
• Manufacturer: Atmel Corporation

Specifications of AT89LP213

• Flash (kbytes): 2 Kbytes
• Max. Operating Frequency: 20 MHz
• Cpu: 8051-1C
• Max I/o Pins: 14
• Spi: 1
• Sram (kbytes): 0.125
• Operating Voltage (vcc): 2.4 to 5.5
• Timers: 2
• Isp: SPI/OCD
• Watchdog: Yes

Figure 11-3. Reset Recovery from Power-down.
Table 11-1.
12. Interrupts
3538E–MICRO–11/10
Symbol
SMOD1
SMOD0
PWDEX
POF
GF1, GF0
PD
IDL
PCON = 87H
Not Bit Addressable
Bit
Function
Double Baud Rate bit. Doubles the baud rate of the UART in Modes 1, 2, or 3.
Frame Error Select. When SMOD0 = 1, SCON.7 is SM0. When SMOD0 = 1, SCON.7 is FE. Note that FE will be set after
a frame error regardless of the state of SMOD0.
Power-down Exit Mode. When PWDEX = 1, wake up from Power-down is externally controlled. When PWDEX = 1, wake
up from Power-down is internally timed.
Power Off Flag. POF is set to “1” during power up (i.e. cold reset). It can be set or reset under software control and is not
affected by RST or BOD (i.e. warm resets).
General-purpose Flags
Power-down bit. Setting this bit activates power-down operation.
Idle Mode bit. Setting this bit activates Idle mode operation
PCON
SMOD1
7
– Power Control Register
INTERNAL
INTERNAL
CLOCK
RESET
The AT89LP213/214 provides 7 interrupt sources: two external interrupts, two timer interrupts, a
serial port interrupt, a general-purpose interrupt, and an analog comparator interrupt. These
interrupts and the system reset each have a separate program vector at the start of the program
memory space. Each interrupt source can be individually enabled or disabled by setting or clear-
ing a bit in the interrupt enable register IE. The IE register also contains a global disable bit, EA,
which disables all interrupts.
Each interrupt source (except the analog comparator) can be individually programmed to one of
four priority levels by setting or clearing bits in the interrupt priority registers IP and IPH. The
analog comparator is fixed at the lowest priority level. An interrupt service routine in progress
can be interrupted by a higher priority interrupt, but not by another interrupt of the same or lower
priority. The highest priority interrupt cannot be interrupted by any other interrupt source. If two
requests of different priority levels are pending at the end of an instruction, the request of higher
priority level is serviced. If requests of the same priority level are pending at the end of an
XTAL1
SMOD0
PWD
RST
6
PWDEX
5
POF
4
GF1
t SUT
3
GF0
2
Reset Value = 000X 0000B
AT89LP213/214
PD
1
IDL
0
19