3336-1 Peregrine Semiconductor, 3336-1 Datasheet - Page 9

• Manufacturer Part Number: 3336-1
• Description: EVAL KIT FOR PE3336
• Manufacturer: Peregrine Semiconductor
• Series: -r

Specifications of 3336-1

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 3336-01

Evaluation Kit Setup
1. Verify a jumper is placed on the connector J3 and REF Selector (JP1) is positioned
2. Connect power supply cables to the Evaluation Kit board as shown in Figure 1.
3. Using the application software provided and described in detail in the next section,
4. Direct mode programming can be evaluated manually without the Application
5. The output of the on-board VCO can be measured by connecting a spectrum
6. Refer to the next section for further information on configuring and running the
Peregrine Semiconductor Corportation
! Connect the +3 V supply to VccPLL (J7 Pins 1 & 3)
! Connect the +5 V supply to VccVCO (J7 Pins 31 & 33)
! Connect the ±6 V supply to VccOpAmp
to select the on-board reference as shown in Figure 2.
Verify all supplies are turned off prior to connecting to evaluation board.
serial and direct programming can be evaluated. To enable software control of the
evaluation board, ensure all DIP switches are turned OFF except for ENH (S1-1) and
A3-S_Mode (S3-8) as shown in Figure 2.
interface and GND) should be connected from your computer’s printer port to J1 on
the evaluation board to enable software control.
Software enabled. To enable direct mode programming, both the ENH (S1-1) and
the Bmode (S3-1) DIP switches should be turned on. The on-board DIPswitches
can then be used to manually program the PLL. Note that M7 register is not
available in the direct mode programming. Instructions for programming PLL
registers are available in the datasheet.
analyzer to port J5. Additional GND posts and test points are available on the
Evaluation Board for measurement flexibility.
application software.
J7-13:
J7-15 & J7-17:
J7-19:
+6 V Red Connector
GND Green Connector
-6 V Black Connector

9
The 4-wire interface cable (3-wire serial
Doc. 79/0056~00A