P420HW02 V0 AU Optronics Corporation, P420HW02 V0 Datasheet - Page 29

• Manufacturer Part Number: P420HW02 V0
• Manufacturer: AU Optronics Corporation

Specifications of P420HW02 V0

• Lead Free Status / Rohs Status: Supplier Unconfirmed

©Copyright AU Optronics, Inc.
January, 2008 All Rights Reserved.
No Reproduction and Redistribution Allowed
www.braemac.co.uk
[e-mail]
9-2 OPERATING PRECAUTIONS
9-3 ELECTROSTATIC DISCHARGE CONTROL
9-4 PRECAUTIONS FOR STRONG LIGHT EXPOSURE
9-5 STORAGE
9-6 HANDLING PRECAUTIONS FOR PROTECTION FILM
(1) The spike noise causes the mis-operation of circuits. It should be lower than following voltage:
(2) Response time depends on the temperature. (In lower temperature, it becomes longer..)
(3) Brightness depends on the temperature. (In lower temperature, it becomes lower.) And in
(4) Be careful for condensation at sudden temperature change. Condensation makes damage to
(5) When fixed patterns are displayed for a long time, remnant image is likely to occur.
(6) Module has high frequency circuits. Sufficient suppression to the electromagnetic interference
Since a module is composed of electronic circuits, it is not strong to electrostatic discharge. Make
certain that treatment persons are connected to ground through wrist band etc. And don’t touch
interface pin directly.
Strong light exposure causes degradation of polarizer and color filter.
When storing modules as spares for a long time, the following precautions are necessary.
(1) Store them in a dark place. Do not expose the module to sunlight or fluorescent light. Keep the
(2) The polarizer surface should not come in contact with any other object. It is recommended that
(1) The protection film is attached to the bezel with a small masking tape. When the protection film
(2) When the module with protection film attached is stored for a long time, sometimes there
V= 200mV(Over and under shoot voltage)
lower temperature, response time (required time that brightness is stable after turned on)
becomes longer.
polarizer or electrical contacted parts. And after fading condensation, smear or spot will occur.
shall be done by system manufacturers. Grounding and shielding methods may be important
to minimize the interface.
temperature between 5
they be stored in the container in which they were shipped.
is peeled off, static electricity is generated between the film and polarizer. This should be
peeled off slowly and carefully by people who are electrically grounded and with well ion-blown
equipment or in such a condition, etc.
and 35
Tel: [phone]
Fax: [phone]
P420HW02 V0
at normal humidity.
28/28