ES1B 60-120C Omron, ES1B 60-120C Datasheet - Page 6

• Manufacturer Part Number: ES1B 60-120C
• Description: Sensor Hardware & Accessories IR Thermosensor 60-120C
• Manufacturer: Omron

Specifications of ES1B 60-120C

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Precautions
Precautions for Safe Use
1. Use the ES1B only within the ranges specified by its specifica-
2. Be sure to correctly wire the input sensor leads to the proper pos-
3. Do not use the product in the following locations:
6
If this product should malfunction and cease to provide
correct output, property damage may occur to the
equipment or device that is connected to it. To prevent
this, provide additional safety measures by also
connecting the equipment or devices to a separate alarm
system that will warn operators of temperature increase.
tions and ratings.
itive and negative terminals.
• Locations subject to icing or condensation.
• Locations subject to excessive shocks or vibration.
• Locations subject to dust or corrosive gases.
• Locations subject to extreme temperature changes or direct
• Locations subject to water splashing or oil contact.
sunlight.
Infrared Thermosensor
!CAUTION
ES1B
Precautions for Correct Use
1. The thermocouple output and power supply are not isolated.
2. To prevent inductive noise, wire the product separately from high-
3. Do not allow the filter to become soiled. Use air blow or use a thin
1. Installation
• Select a place where the emissivity is high for measuring the target.
• Use the supplied locknuts to fix the ES1B securely in place. Tighten
• When measuring a high-temperature object, use a shield or similar
2. Connection
• Connect to the green output lead wire (+), white output lead wire
• To measure the temperature difference between two locations, use
3. Adjustment
• The output impedance of the ES1B is 1 to 4 kΩ. Normally, current
• If the length of a lead wire must be extended, use a K thermocouple
• Do not bend lead wires repeatedly.
4. Cleaning
• Do not use paint thinner or the equivalent for cleaning. Use stan-
If necessary, use black spray or black tape.
to a torque of 0.5 N·m max.
protection to prevent the temperature of the ES1B from rising.
(−), orange power supply lead wire (+), and shield power supply
wire (−).
two isolated power supplies.
leaking to the ES1B from the burnout detection circuit of the tem-
perature controller will offset the measured temperature in a range
extending from several degrees to several tens of degrees. When
using a controller equipped with an input shift function, use the
input shift function to compensate for this offset error in the vicinity
of the measuring temperature. For details on this compensation,
see Input Shift Method section and the user's manual of the control-
ler being used.
compensating conductor for the output lead wires (+, −), and stan-
dard copper wire for power supply leads (+, −).
dard grade alcohol.
Make sure that unwanted circuit paths are not formed with the
equipment or device that is connected to the product.
voltage sources and power lines carrying large currents. Also
avoid parallel wiring or shared wiring paths with power lines.
cotton swab to clean the filter.