NL6448AC33-29 NEC Electronics, NL6448AC33-29 Datasheet - Page 21

• Manufacturer Part Number: NL6448AC33-29
• Manufacturer: NEC Electronics

Specifications of NL6448AC33-29

• Lead Free Status / Rohs Status: Not Compliant

GENERAL CAUTIONS
(1) Caution when taking out the module
(2) Cautions for handling the module
(3) Cautions for the atmosphere
(4) Caution for the module characteristics
Next figures and sentence are very important. Please understand these contents as follows.
a) Pick the pouch only, in taking out module from a carrier box.
a) As the electrostatic discharges may break the LCD module, handle the LCD module with care against
b)
c) As the surface of polarizer is very soft and easily scratched, use a soft dry cloth without chemicals for
d) Do not pull the interface connectors in or out while the LCD module is operating.
e) Put the module display side down on a horizontal plane.
f)
g) When the module is operating, do not lose CLK, Hsync or Vsync signal. If any one of these signals is lost,
h)
i)
a) Dew drop atmosphere should be avoided.
b) Do not store and/or operate the LCD module in a high temperature and/or high humidity atmosphere.
c) This module uses cold cathod fluorescent lamp. Therefore, the life time of the lamp becomes short if the
d) Do not operate the LCD module in a high magnetic field.
a) Do not apply fixed pattern data signal for a long time to the LCD module. It may cause image sticking.
Do not touch an inverter, on which is stuck a caution label, while the LCD module is under the operation, because
of dangerous high voltage.
CAUTION
electrostatic discharges.
cleaning.
Handle connectors and cables with care.
the LCD panel would be damaged.
Don’t push or rub the surface of LCD module.
If you do, the scratches or rubbing marks may be left there.
Storage in an electro-conductive polymer packing pouch and under relatively low temperature atmosphere
is recommended.
module is operated in the low temperature environment.
Please use screen savers if the display pattern is fixed more than one hour.
The torque to mounting screw should never exceed 0.294 N·m (3 kgf·cm).
CAUTION
This figure is a mark that you will get an electric shock when you make a mistake to operate.
This figure is a mark that you will get hurt when you make a mistake to operate
As the LCD panel and backlight element are made from fragile glass material, impulse and
pressure to the LCD module should be avoided.
This figure is a mark that you will get hurt and/or the module will have damages when you make
a mistake to operate.
Data Sheet EN0439EJ1V0DS00
NL6448AC33-29
21