TX20D19VM2BAA HITACHI, TX20D19VM2BAA Datasheet - Page 20

• Manufacturer Part Number: TX20D19VM2BAA
• Manufacturer: HITACHI

Specifications of TX20D19VM2BAA

• Lead Free Status / Rohs Status: Compliant

ELECTRONICS CO., LTD.
12. PRECAUTIONS
12.1 PRECAUTIONS of ESD
1) Before handling the display, please ensure your body has been connected to ground to avoid any
2) Please remove the protection film very slowly before turning on the display to avoid generating ESD.
12.2 PRECAUTIONS of HANDLING
1) In order to keep the appearance of display in good condition, please do not rub any surfaces of the
2) Please do not stack the displays as this may damage the surface. In order to avoid any injuries,
3) Touching the polarizer or terminal pins with bare hand should be avoided to prevent staining and
4) Do not use any harmful chemicals such as acetone, toluene, and isopropyl alcohol to clean display’s
5) Please use soft cloth or absorbent cotton with ethanol to clean the display by gently wiping.
6) Please wipe any unknown liquids immediately such as saliva, water or dew on the display to avoid
7) Maximum pressure to the surface of the display must be less than
12.3 PRECAUTIONS OF OPERATING
1) Please input signals and voltages to the displays according to the values defined in the section of
2) When the display is operating at significant low temperature, the response time will be slower than it
3) The use of screen saver or sleep mode is recommended when static images are likely for long
4) Spike noise can cause malfunction of the circuit. The recommended limitation of spike noise is no
KAOHSIUNG HITACHI
at 25
However, these are temperature-related phenomenon of LCD and it will not cause permanent
damages to the display when used within the operating temperature.
damages by ESD. Also, do not touch display’s interface directly when assembling.
displays by sharp tools harder than 3H, especially touch panel, metal frame and polarizer.
please avoid touching the edge of the glass or metal frame and wore gloves during handling.
poor electrical contact.
surfaces.
Moreover, when wiping the display, please wipe it by horizontal or vertical direction instead of
circling to prevent leaving scars on the display’s surface, especially polarizer.
color fading or any permanently damages.
adding pressure is less than 1
electrical characteristics to obtain the best performance. Any voltages over than absolute maximum
rating will cause permanent damages to this display. Also, any timing of the signals out of this
specification would cause unexpected performance.
periods of time. This is to avoid the possibility of image sticking.
bigger than
C

. In high temperature, the color will be slightly dark and blue compared to original pattern.

100 mV.
SHEET
NO.
cm
2
, the maximum pressure must be less than 1.96N.
7B64PS 2712-TX20D19VM2BAA-3
1,96
x
10
4
Pa. If the area of
PAGE
12-1/2