LQ035Q7DH06/ES Sharp Electronics, LQ035Q7DH06/ES Datasheet - Page 20

• Manufacturer Part Number: LQ035Q7DH06/ES
• Manufacturer: Sharp Electronics

Specifications of LQ035Q7DH06/ES

• Lead Free Status / Rohs Status: Supplier Unconfirmed

12-3) Design guidance for touchpanel(T/P)
12-3-1) Example of housing design
12-3-2) Mounting on display and housing bezel
(1)If a consumer will put a palm on housing in normal usage, care should be taken as follows.
(3)Insertion a cushion material is recommended.
(4)The cushion material should be limited just on the busbar insulation paste area.
(5)There is one where a resistance film is left in the T/P part of the end of the pole.
(4)Top layer, PET, dimension is changing with environmental temperature and humidity.
(5)The input to the Touchpanel sometimes distorts touch panel itself.
(2)Keep the gap, for example 0.3 to 0.7mm, between bezel edge and T/P surface.
(1)In all cases, the T/P should be supported from the backside of the Plastic.
(2)Do not to use an adhesive-tape to bond it on the front of T/P and hang it to the housing bezel.
(3)Never expand the T/P top layer (PET-film) like a balloon by internal air pressure.
Insulation Paste
If it is over the transparent insulation paste area, a ”short” may be occurred.
Design to keep insulation from the perimeter to prevent from mis-operation and so on.
Avoid a stress from housing bezel to top layer, because it may cause “waving”.
The life of the T/P will be extremely short.
The reason is to avoid the bezel edge from contacting T/P surface that may cause a “short”
with bottom layer. (See Fig.2)
Insulation metal
Cushion material
Transparent
(=Gasket Area)
PET Film
Glass
Housing
Prohibition Area
Fig.2
Response Area
Electrode
Layer
0.3
～0.7mm
LD-21909A-17