NL128102AC28-07 Renesas Electronics America, NL128102AC28-07 Datasheet - Page 24

• Manufacturer Part Number: NL128102AC28-07
• Manufacturer: Renesas Electronics America

Specifications of NL128102AC28-07

• Lead Free Status / Rohs Status: Supplier Unconfirmed

24
(2) Environment
(3) Specification for products
(4) Other
General specifications for the LCD
The following items are neither defects nor failures.
∗ Response time, luminance and color gamut may be change by ambient temperature.
∗ The LCD may be seemed luminance uniformity, flicker, vertical seam and/or small sport by display
∗ Optical characteristics (e.g. luminance, display uniformity, etc.) gradually is going to change de-
1
2
3
4
1
2
3
4
1
2
3
4
5
patterns.
pending on operating time, and especially low temperature, because the LCD has cold cathode
fluorescent lamps.
Dewdrop atmosphere must be avoided.
Do not operate and/or store in high temperature and/or high humidity atmosphere. If customer stores the
product, keep in antistatic pouch in room temperature, because of avoidance for dusts and sunlight.
Do not operate in high magnetic field. Circuit boards may be broken down by it.
Use an original protection sheet on product surface (polarizer). Adhesive type protection sheet should
be avoided, because it may change color and/or properties of the polarizer.
Do not display the fixed pattern for a long time because it may cause image sticking. If the fixed pattern
is displayed on the screen, use a screen saver.
The product may be changed of color by viewing angle because of the use of condenser sheet for backlight
unit.
The product may be changed of luminance by voltage variation, even if power source applied recom-
mended voltage to backlight inverter.
Optical characteristics may be changed by input signal timings.
All GND, GNDB, V
Do not disassemble a product and/or adjust volume.
If customer would like to replace backlight lamps, see ‘REPLACEMENT MANUAL FOR BACKLIGHT’.
If customer uses screwnails, pay attention not to insert waste materials in inside of products.
When customer returns product for repair and so on, pack it with original shipping package because of
avoidance of some damages during transportation.
DD
and V
DDB
terminals should be connected without a non-connected signal line.
Data Sheet EN0537EJ1V0DS
NL128102AC28-07