2106946-2 TE Connectivity, 2106946-2 Datasheet - Page 5

• Manufacturer Part Number: 2106946-2
• Description: Solderless LED Socket
• Manufacturer: TE Connectivity
• Type: Wire to Boardr

Specifications of 2106946-2

• Holder Type: Socket
• No. Of Leds: 1
• External Length: 38.7mm
• Holder Material: Thermoplastic
• Accessory Type: LED Socket
• Rohs Compliant: Yes
• Product: Socket Connectors
• Mounting Style: Wire Connection
• Termination Style: Snap In
• Contact Plating: Silver
• Contact Material: Copper Alloy
• Housing Material: Thermoplastic
• Current Rating: 500 mA
• Voltage Rating: 30 VDC
• Height: 6.5 mm
• Length: 38.7 mm
• Number Of Positions: 6
• Width: 27.5 mm
• Product Type: Socket
• Product Series: CM
• Termination Method To Wire/cable: 6 Conductor AMP Mini CT Connector
• Operating Voltage (vdc): 30
• Current, Maximum (ma): 500
• Socket Type: LED to Wire
• Optics Latch: With
• Contact Base Material: Copper Alloy
• Contact Plating, Mating Area, Material: Silver
• Ul Flammability Rating: UL 94V-0
• Rohs/elv Compliance: RoHS compliant, ELV compliant
• Lead Free Solder Processes: Not relevant for lead free process
• Rohs/elv Compliance History: Always was RoHS compliant
• Applies To: Wire/Cable
• Application: Termination for Cree XLamp® MP-L™ LED
• For Use With: Cree XLamp MP-L LED's & LEDIL Tyra Reflectors
• Lead Free Status / Rohs Status: Details

4.
4.1.
4.2.
4.3.
4.4.
Rev O4
QUALITY ASSURANCE PROVISIONS
Qualification Testing
A.
B.
Requalification Testing
If changes significantly affecting form, fit or function are made to the product or manufacturing process,
product assurance shall coordinate requalification testing, consisting of all or part of the original testing
sequence as determined by development/product, quality and reliability engineering.
Acceptance
Acceptance is based on verification that the product meets the requirements of Figure 1. Failures
attributed to equipment, test setup or operator deficiencies shall not disqualify the product. If product
failure occurs, corrective action shall be taken and specimens resubmitted for qualification. Testing to
confirm corrective action is required before resubmittal.
Quality Conformance Inspection
The applicable quality inspection plan shall specify the sampling acceptable quality level to be used.
Dimensional and functional requirements shall be in accordance with the applicable product drawing
and this specification.
Specimen Selection
Specimens shall be prepared in accordance with applicable Instruction Sheets and shall be
selected at random from current production. Each test group shall consist of a minimum of 5
specimens.
Test Sequence
Qualification inspection shall be verified by testing specimens as specified in Figure 2.
108-2439
5 of 6