B39431B3760Z810 EPCOS Inc, B39431B3760Z810 Datasheet - Page 5

• Manufacturer Part Number: B39431B3760Z810
• Description: FILTER SAW 433.92MHZ REMOTE SMD
• Manufacturer: EPCOS Inc
• Type: SAW Componentr
• Series: B3760r

Specifications of B39431B3760Z810

• Frequency: 433.92MHz Center
• Package / Case: 0.150" L x 0.150" W x 0.059" H (3.80mm x 3.80mm x 1.50mm)
• Bandwidth: 120kHz
• Insertion Loss: 1.9dB
• Filter Type: Bandpass
• Applications: Remote Control
• Mounting Type: Surface Mount
• Product: RF SAW Filters
• Frequency Range: 433.76 MHz to 434.08 MHz
• Impedance: 50 Ohms
• Operating Temperature Range: - 45 C to + 125 C
• Voltage Rating: 6 Volts
• Termination Style: SMD/SMT
• Saw Filter Type: SAW Filter
• 3db Bandwidth: 740KHz
• Center Frequency: 433.92MHz
• Termination Impedance: 50Ohm
• Package Type: QCC8B
• Case Height: 1.5mm
• Case Length: 3.8mm
• Case Depth: 3.8mm
• Mounting: Surface Mount
• Pin Count: 8
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: 495-1672-2; B39431B3760Z810W1; B39431B3760Z810W3

Data sheet
Matching network to 50
Minimising the crosstalk
For a good ultimate rejection a low crosstalk is necessary. Low crosstalk can be realised with a good
RF layout. The major crosstalk mechanism is caused by the “ground-loop” problem.
Grounding loops are created if input-and output transducer GND are connected on the top-side of
the PCB and fed to the system grounding plane by a common via hole. To avoid the common
ground path, the ground pin of the input- and output transducer are fed to the system ground plane
(bottom PCB plane) by their own via hole. The transducers’ grounding pins should be isolated from
the upper grounding plane.
A common GND inductivity of 0.5nH degrades the ultimate rejection (crosstalk) by 20dB.
The optimised PCB layout, including matching network for transformation to 50 Ohm, is shown
here. In this PCB layout the grounding loops are minimised to realise good ultimate rejection
Optimised PCB layout for SAW filters in QCC8B package, pinning 2,5 (top side, scale 1:1)
The bottom side is a copper plane (system ground area). The input and output grounding pins are
isolated and connected to the common ground by separated via holes.
For good contact of the upper grounding area with the lower side it is necessary to place enough
via holes.
Please read cautions and warnings and
important notes at the end of this document.
SAW Components
SAW filter
(element values depend on pcb layout and equivalent circuit)
5
May 19, 2009
L
L
s1
s2
= 33
= 33 nH
nH
433.92 MHz
B3760